Summary of Contents for EVO Powerboards Evo R
-
Page 1: Warranty Information
PLEASE READ MANUAL IT WOULD ALLOW YOU TO ENJOY YOUR POWERBOARD MORE OWNER’S: MANUAL WARRANTY INFORMATION ALWAYS WEAR A HELMET!!! PLEASE BE SAFE WHEN RIDING!!! -
Page 2: Table Of Contents
TABLE OF CONTENTS: Description Page A.Table of Contents B.Important!!! C.Safety ____________________________________________ D.Getting to Know YOUR Powerboard E.Package Contents F.Getting Started G.Folding and Storage ____________________________________________ H.Operating Procedures I.Fuel Mixture Table J.Maintenance Recommended Tools Carburettor Adjustments Cleaning the Airfilter Braking System Tyres and Wheels Adjusting the Head Unit Adjusting the Belt and Chain Maintenance Schedule... -
Page 3: B.important
IMPORTANT!!! PLEASE READ THIS FIRST BEFORE OPERATING THIS PRODUCT WHERE TO USE POWERBOARD: This product does not conform to Local Motor Vehicle Standards and is not intended for operation on public streets, roads or highways. Serious injury can result from the unsafe operations of this vehicle. -
Page 4: C.safety
SAFETY Fuel Safety • Mix and pour fuel outdoors away from sparks or flames. • Use only a container approved for fuel. • Do not smoke or allow smoking near the Powerboard while working on the engine, or while the engine is running. •... -
Page 5: D.getting To Know Your Powerboard
GETTING TO KNOW YOUR POWERBOARD Gas Lever Front Brake Lever Disc Brake 2-Stroke Engine Folding Handle Kickstand Head Unit Deck Brake Calliper 10. Kill Switch 11. Chain Pulley 12. Mud Guard 13. Handlebar Tube 14. Recoil Starter 15. Gas Tank 16. -
Page 6: E.package Contents
E.PACKAGE CONTENTS Your EVO Powerboard comes with the following items in the box. Please locate all of the following: 1. The EVO Powerboard 2. Allen Wrench 3. Owner’s Manual 4. Seat Post (Optional) F.GETTING STARTED Please read and understand these instructions and the OPERATING PROCEDURES section, prior to starting or riding your EVO Powerboard! Unfolding Carefully remove the EVO Powerboard from... - Page 7 Clean the tank cap area to make sure that it is Fig. 4 free from excess dirt and debris. * Make sure that no dirt falls into the gas tank! 10. Pour pre-mixed Gas/Oil mixture into the GAS TANK. Tank capacity is 0.9 litres. * Fill to below the Fuel Pipe entry plug, do not overfill.
-
Page 8: G.folding And Storage
18. Make sure that all of the exposed bolts and screws are tightened. 19. Raise the kickstand to its upright position. 20. Make sure the engine is running. 21. Put one foot on the deck of the EVO Powerboard. While pushing off with the other foot, gently depress the GAS LEVER, on the right side of the handlebars. -
Page 9: I.fuel Mixture Table
I.Fuel : Oil Mixing Table Litres of Oil Ratio (ml of oil) Leaded POOR QUALITY BEST QUALITY Petrol 20:1 30:1 40:1 50:1 60:1 20 litres 1 litre 660ml 500ml 400ml 330ml 15 litres 750ml 500ml 370ml 300ml 250ml 10 litres 500ml 330ml 250ml... -
Page 10: Carburettor Adjustments
CARBURETTOR ADJUSTMENT WARNING! Never start the engine without the complete clutch cover assembled! Otherwise the clutch can come loose and cause personal injuries. In the Carburettor, fuel is mixed with air. When the engine is test run at the factory, the Carburettor is basically adjusted. -
Page 11: Cleaning The Airfilter
When the idle speed is adjusted properly, the engine Fig. 9 will run smoothly, without pressing the GAS LEVER. Adjusting the Idle Speed Screw: Start the engine. Using a long, Philips head screwdriver gently close (clockwise) the T-screw until the Big Boy Powerboard starts to move forward. -
Page 12: Braking System
TYRES AND WHEELS The EVO R Powerboard uses an identical rim and tyre assembly on the front and rear wheels, which means that the tyres can be rotated. The wheels are actually two wheel halves (split rim) bolted together to make it easier to remove and replace the tyre and tube. -
Page 13: Adjusting The Head Unit
The rear wheel is fitted with a special spacer to accommodate the belt pulleys, while the front wheel has a bracket for the disc brake. Tyre wear will differ based on rider weight, riding conditions and care. Replacement tyres can be obtained at your local EVO Powerboard Dealer or from the EVO Website at: www.evopowerboards.com Tyre Pressure The tyre must be inflated between 2 and 2,5 Bar. -
Page 14: Adjusting The Belt And Chain
ADJUSTING THE BELT AND CHAIN The belt and chain will come adjusted from the factory. However, it may be necessary to adjust the pulleys from time to time. The belt and chain must be well aligned onto the pulleys otherwise they may start to rub and chafe, which will result in shortened belt and chain life. -
Page 15: Maintenance Schedule
With both spanner and allen key, adjust the Fig. 19 tension (Fig. 19). Ensure that the lock nut is securely fastened against the plate. If this is not done correctly, the chain will loosen immediately and there is a possibility of loosing the bolt. MAINTENANCE SCHEDULE Proper care of your Powerboard will ensure optimal performance and longer life span. -
Page 16: Www.evopowerboards.com
1. Labour: For a period of 3 months from the date of purchase, if this Product is determined to be defective, EVO Powerboards will repair the Product at no charge or pay the labour charges to any EVO Authorized Service Facility. After the Warranty Period, you must pay for all labour charges.
Need help?
Do you have a question about the Evo R and is the answer not in the manual?
Questions and answers