Wassp Transfer Task Settings - Wassp WMB-3250 Installation Manual

8.2

WASSP Transfer Task Settings

Connect the sensors to the PC via the serial cables. Once the sensors are turned on, the
WASSP Transfer Task can be configured to read the NMEA sentence output from each of the
connected sensors.
The WASSP Transfer Task has three tabbed pages for configuring serial transfer settings:
NMEA:
►
Network
►
RTS/CTS
►
To open the WASSP Transfer Task window and enter the NMEA and communication port
settings:
Right-click the WASSP Transfer Task icon
1
on the Windows Task bar. Click Setup.
The WASSP Transfer Task opens.
The NMEA Settings are used to configure the
2
transport protocol between sensors and the
WASSP system.
Select the appropriate COM Port and configure as
required for the sensor.
For full details on installation and connection, refer
to Equipment Manuals.
Figure 22. WASSP Transfer Task NMEA Tab
Page 28 of 73
See "Figure 22. WASSP Transfer Task NMEA Tab" on page 28
www.wassp.com
Installation Manual
Note: If the WASSP Transfer Task
icon is not available on the Task
Bar, click Start > All Programs >
WASSP > Transfer Task.
The Activity indicator will show
data activity. Green is connected
and active, clear is not active
and red indicates an error on the
COM port.
Select Monitor to see the real-
time output sentences from the
sensor in the display area.
The display area.
Doc. P/N:
Version:
Issue Date:
WSP-009-005
V1.5
October 2013