Installation INSTALLATION Location When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated with an average room temperature of between 16°C and 32°C. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption.
Page 3
INSTALLATION 2. Remove the top right hinge cover. 3. Undo the screws. Then remove the hinge bracket. unscrew 4. Remove the top left screw cover. 5. Move the core cover from left side to right side. And then lift the upper door and place it on a padded surface to prevent it from scratching.
Page 4
INSTALLATION 6. Take off the middle hinge by removing the screws. And then lift the lower door and place it on a padded surface to prevent it from scratching. 7. Remove the screws’ covers and place them to the opposite side. 8.
Page 5
INSTALLATION 10. Refit the bracket fitting the bottom hinge pin. Replace both adjustable feet. Transfer the lower door to the property position. Screw 11. Move the hinge hole cover of lower door from left side to right side. 12. Make the middle hinge reverse the direction 180°C, then transfer it to the left property position.
INSTALLATION 16. Put the hinge cover and the screw cover back. 17. With the doors closed, check that the doors are aligned horizontally and vertically and that the seals are closed on all sides before finally tightening the bottom hinge. Re-adjust the levelling feet as needed.
INSTALLATION Cleaning Before Use Wipe the inside of the unit with a weak solution of bicarbonate soda. Then rinse with warm water using a ‘wrung-out’ sponge or cloth. Wipe completely dry before replacing the shelves and salad bin. Clean the exterior of the unit with a damp cloth. If you require more information refer to the Cleaning section.
Product Overview Freezer Compartment Temperature Control (with integrated Interior light assembly) Wire Shelf Crisper with Glass Cover Leveling Leg Freezer Door Refrigerator Door Can Rack 2-Liter Bottle Bin...
Operation Switching On Your Unit 1. Connect the mains cable to the mains socket. The internal temperature of your unit is controlled by a thermostat. There are eight settings, of which position 7 is the coldest and position 0 turns the unit off.
Shopping for Chilled Foods • Take a quick look at the chilled food package and make sure it is in perfect condition. • Try to keep chilled food together whilst shopping and on the journey home as this will help to keep the food cold.
Preparations for Freezing • Use quality food and handle it as little as possible. Freeze food in small quantities as it freezes faster, takes less time to defrost and enables you to control the quantity you need better. • Leave cooked food to cool completely. Chill food before freezing if possible. •...
Cleaning Defrosting Frost might build up in the freezer compartment after it has been used for a period of time. Scrape away the frost using a plastic scraper (not included). Do not use a metal or sharp instrument to scrape away the frost, nor should you use any electrical appliances to aid defrosting.
Maintenance Changing the Internal Light 1. Before carrying out the bulb replacement always adjust the thermostat control dial to Position 0, then disconnect the mains supply. 2. Use a flat bladed screwdriver and gently prise off the light bulb cover. 3.
Safety Warnings For your continued safety and to reduce the risk of injury or electric shock, please follow all the safety precautions listed below. • Read all instructions carefully before using the unit and keep them for future reference. • Retain the manual.
Need help?
Do you have a question about the CCR312DCE1B and is the answer not in the manual?
Questions and answers