Congratulations on the purchase of your BLUE CLEAN POWER WASHER! Your BLUE CLEAN POWER WASHER is a power tool in every sense of the word that may be used outside your house and in. It is one of the finest most powerful home-use power washers in the marketplace today.
TABLE OF CONTENTS Page Introduction Safeguards, Warnings, and Safety Tips 3,4,5 Package Contents Unpacking & Assembly Operating Instructions Operating Tips and Maintenance 9,10 Storage Pump Saver Troubleshooting Replacement Parts Specifications Limited Warranty & Warranty Returns SAFEGUARDS, WARNINGS AND SAFETY TIPS •...
Page 4
• Never operate the power washer in bare feet, sandals, or open-toed shoes. • When using the power washer near children make sure they are closely supervised by an adult to avoid injury. Never let a child use the power washer.
Page 5
• IMPORTANT: Store the power washer indoors to prevent the water in the unit from expanding under freezing conditions. When the water freezes and expands, your power washer will be damaged and become inoperable. Or, if storing outdoors, it is recommended you use Pump Saver. Pump Saver can be purchased on our website: www.arblueclean.com.
Fig. 1 Fig. 2 • Install the accessory holder on the back of your BLUE CLEAN POWER WASHER (Fig. 1). You’ll notice where the accessory holder meets the back of the unit. You will see several male index posts which fit into female holes. The posts and holes enable easy placement of the accessory holder and easy tightening of the screws.
Page 8
Fig. 12 Fig. 13 connected to the clear adapter. • You have now completed the assembly of your BLUE CLEAN POWER WASHER and are now ready to begin using your electric power washer. Read and observe all safety instructions. Fig. 14...
OPERATING INSTRUCTIONS • Turn on the water supply at the faucet. • Make sure the “ON/OFF” switch is in the “OFF” position. The power switch has international symbols for ‘on’ and ‘off’: On (--) Off (O). (Fig. • Unwind the power cord completely and plug the GFCI into a grounded Fig.
Page 10
How to Avoid Damaging Surfaces • Damage to surfaces being cleaned occurs because the impact force of the water pressure exceeds the durability of the surface. Bare wood can be penetrated; paint can be peeled off, etc. You can vary the force of your power washer by controlling: o the fan pattern of the nozzle (when using the adjustable nozzle) o the angle of the surface being cleaned...
STORAGE • When your pressure washing session has been completed, turn off the power switch located on the back of the power washer. Unplug the power cord from the outlet. Turn off the water supply. Pull the trigger on the spray gun 2-3 times to drain out the excess water and to release any remaining water pressure.
Pump Saver is a product that protects and prolongs the life of the pump. This will keep the internal parts of the pump lubricated and protected from freezing while being stored in ALL climates. It also assists with protection from internal corrosion. The Blue Clean part # is: PW64511 (16oz. bottle ).
TROUBLESHOOTING AND FAQs Unit will not turn Make sure the power washer is in the “OFF” position. Plug in the electrical cord to a grounded 120 volt outlet (no electrical extension cord should be used). If the electrical cord will not plug into your outlet, your electrical outlet is not properly grounded and should not be used.
Cleaning and troubleshooting tips, manuals and other helpful information are available on our website. For parts and accessories for your Blue Clean washer, visit www.arblueclean.com. Ordering is easy and all major credit cards are accepted. A.R. NORTH AMERICA, INC.
Need help?
Do you have a question about the AR383 and is the answer not in the manual?
Questions and answers