Connecting The Power Supply; Putting The Robot Pool Cleaner Into The Pool - Maytronics Dolphin Bio Suction User Manual/Instructions

9. TROUBLESHOOTING
Problem Solution
Cable twisting or cable coils up. 1. Check for an obstruction in the pool.
2. Remove excess cable from the pool.
3. Clean the filters cartridges.
4. Straighten cable and lay it in the sun periodically.
The robot is moving in circles or 1. Check for foreign objects in moving parts.
does not reach all areas of the pool. 2. Make sure filters cartridges are clean and well-mounted and that
the filter covers are closed.
3. Make sure that there is enough cable laid out to cover the whole
pool.
The robot is not moving sideways on Adjust the diagonal angle of the handle.
walls.
The robot does not climb walls. 1. Clean the filter cartridge.
2. If this is the beginning of the season, use a coarse net filter to
remove large debris.
3. Check if brushes are worn and replace them if necessary.
4. Make sure the impeller area is clean.
5. Check that the remote control is set for climbing.
The robot is disengaging from wall If the robot climbs too high, consult your Dolphin distributor.
at water-line.
Remote control unit is not working. Check if the batteries need to be replaced.
Motor is not working. 1. Check if the impeller is blocked.
2. Check if the drive system is blocked.
3. Check power source.
If power is in order, please contact your Dolphin distributor.
Pipe is twisting. The pipe might be too long. Use only the minimum length of pipe
necessary for the robot to reach all corners of the pool.
The robot does not climb walls with Increase the external pump's suction.
external pump.
Additional troubleshooting is available on our website:
www.maytronics.com
16 Dolphin Bio Suction | User Instructions Manual

5.3. Connecting the power supply

Attach the floating cable to the
power supply.
Insert it by lining up the connector
notch (1) with the groove in the
socket and turning clockwise (2).

5.4. Putting the robot pool cleaner into the pool

Dolphin Bio Suction | User Instructions Manual
2
1
Plug in the power supply and leave it turned off.
Place the robot pool cleaner in the pool and
release it.
5