Wireless Lan Advanced Screen; Wps Screen - ZyXEL Communications NBG-418N User Manual

6.6 Wireless LAN Advanced Screen

Use this screen to allow intra-BSS networking and set the RTS/CTS Threshold.
Click Network > Wireless LAN > Advanced. The screen appears as shown.
Figure 48 Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
Table 24 Network > Wireless LAN > Advanced
LABEL
Wireless Advanced Setup
Tx Power
Enable Intra-BSS
Traffic
Apply
Reset

6.7 WPS Screen

Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click Network > Wireless LAN > WPS tab.
Chapter 6 Wireless LAN
DESCRIPTION
This field controls the transmission power of the NBG-418N v2. If there is a high density
of APs in an area, decrease the output power of the NBG-418N v2 to reduce interference
with other APs.
A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is
enabled, wireless client A and B can access the wired network and communicate with
each other. When Intra-BSS is disabled, wireless client A and B can still access the wired
network but cannot communicate with each other.
Click Apply to save your changes to the NBG-418N v2.
Click Reset to reload the previous configuration for this screen.
NBG-418N v2 User's Guide
69