Contents 1. Welcome 5. Special use cases 5.1 RemoteMic and phone calls 2. Getting to know your RemoteMic 5.2 RemoteMic and watching TV 2.1 Device description 5.3 RemoteMic streaming distance 2.2 Compatibility note 5.4 Using the securing cord 2.3 Streaming stability note 5.5 Deleting all Bluetooth pairings...
Please read the user instructions thoroughly in order to be able to benefit from all the possibilities your hearing system can offer. I will use the RemoteMic along with the following streamer: If you have any questions, please consult your hearing care professional or go to www.phonak.com/remotemic...
2. Getting to know your RemoteMic The RemoteMic sends the speaker’s voice wirelessly to 2.1 Device description your hearing aids via the Phonak streamer. Volume up ( The system consists of three main elements: Volume down ( ...
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Phonak is under license. Other trademarks and trade names are those of their respective owners.
The RemoteMic can be J The typical charging time is 2 hours. charged while the J Charging is complete when the indicator light TVLink II is being used. turns solid green. It is safe to leave the RemoteMic connected to the charger overnight.
Page 7
3. Getting started 3.2 Switching On 3.3 Pairing the RemoteMic Slide the power switch Before using the RemoteMic with a streamer for the first to turn the RemoteMic time, the devices must first be paired with each other. on or off.
Page 8
Put RemoteMic into pairing mode Completion of pairing Wait until both indicator lights turn solid blue. This If the RemoteMic has never been paired, it will can take up to 2 minutes but usually occurs within automatically be in pairing mode for 30 minutes a few seconds.
Indicator light is not Pause mode Blink blue Blink blue mode or off lit at all Pairing mode Rapid blink blue Rapid blink blue Switch the RemoteMic off and on again to turn the device back on from sleep mode.
For a more detailed explanation of the streamers, refer to the streamer’s user guides. If the indicator light is rapidly blinking blue after turning on the RemoteMic or if the indicator light does not turn solid blue within two minutes, repeat the pairing in chapter 3.3.
If you encounter To fine-tune the overall volume of the hearing aids audio drops, please refer to the troubleshooting and the RemoteMic, you may use the streamer volume guide in chapter 6. buttons: to increase the volume...
4. Daily use The RemoteMic volume setting will be stored even Distance to the speaker’s mouth: J The best results are achieved after switching off the RemoteMic. at 20 cm (8"). J A distance of 50 cm (20") should Your hearing care professional can change the level of the hearing aid microphones whilst using not be exceeded.
RemoteMic by sliding the power the main button. switch to the off position. Switch the RemoteMic off when not in use. When paused: J The indicator lights will blink blue on both devices. J Your hearing aids will switch back to the most recent hearing aid program.
5.2 RemoteMic and watching TV If the streamer is paired and connected to your mobile phone, you can still receive phone calls, even when using RemoteMic. In case of an incoming call, the To ensure high quality audio streamer automatically stops transmitting the audio...
For transportation purposes, you can use the detachable 5.3 RemoteMic streaming distance securing cord as shown: The RemoteMic operates up to a range of 20 m (60 ft). Line of sight between your streamer and the RemoteMic is not required. Interference in the environment due to walls, the furniture or the human body may reduce the operating range.
Causes What to do If you encounter problems with one of the paired devices, or if a device stops connecting to your RemoteMic, you I cannot hear the sound from the RemoteMic may consider deleting all pairings from the RemoteMic.
Page 17
I hear breakup during audio transfer There is too much noise, I cannot understand the speaker J Reduce the hearing aid J The RemoteMic device is too J Do not exceed the maximum J Your hearing aid microphones are set too high...
Page 18
What to do Causes What to do RemoteMic is no longer recognized by the streamer it was I see a rapidly blinking blue indicator light on the RemoteMic previously paired with J RemoteMic has never been J Complete the pairing as J 2 minutes after no device has J Switch the streamer off.
7.3 Warranty limitation Please ask the hearing care professional, where you This warranty does not cover damage from improper purchased your streamer and RemoteMic, about the handling or care, exposure to chemicals, immersion in terms of the local warranty. water or undue stress. Damage caused by third parties or non-authorized service centers renders the warranty 7.2 International warranty...
The full text of the Declaration of Conformity can be obtained from the manufacturer or the local Phonak 1) this device may not cause harmful interference, and representative whose address can be taken from 2) this device must accept any interference received, the list on www.phonak.com (worldwide locations).
Page 21
Telecommunications Business Law (電気通信事業法). J Consult the dealer or an experienced radio/TV This device should not be modified (otherwise the granted technician for help. designation number will become invalid).” More details can be found in the product data sheet on www.phonak.com/remotemic...
9. Information and explanation of symbols Important information for handling and product safety. The CE symbol is a confirmation by Phonak AG that this Phonak product EMC and Radio communications meets the requirements of the compliance label Australia. R&TTE Directive 1999/5/EC on Radio...
Page 23
9. Information and explanation of symbols Humidity transportation: Up to 90% The symbol with the crossed-out (non condensing). garbage bin is to make you aware Humidity storage: 0% to 70%, if not that this device may not be thrown in use. away as normal household waste.
For safety reasons, only use chargers supplied by Phonak or stabilized chargers with a rating of 5 VDC, min. 250 mA. Do not charge RemoteMic from a PC or laptop USB port. This may damage your equipment.
Page 25
10. Important safety information Changes or modifications to any of the devices Dispose of electrical components in accordance with that have not been explicitly approved by Phonak your local regulations by Phonak AG. are not permitted. Do not use the device in explosive areas (mines...
Page 26
10. Important safety information Clean devices using a damp cloth. Never use Special medical or dental examination including household cleaning products (washing powder, soap, radiation described below, may adversely affect the etc.) or alcohol to clean them. Never use a correct functioning of your device.
Page 27
Notes 10. Important safety information Other important information J The RemoteMic is a Bluetooth 2.1 compliant device. Its wireless transmission technology is not limited to but optimized for Phonak streamer. J The use of RemoteMic with non-Phonak streamer is not supported by Phonak.
Need help?
Do you have a question about the RemoteMic and is the answer not in the manual?
Questions and answers