On-Q/Legrand F7394-xx Series Instruction/Installation Sheet

Category 5 audio keypad volume control with ir
Hide thumbs Also See for F7394-xx Series:

Advertisement

on-Q
Dlegrand'"
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343/ Fax (717) 702-2546
www.onqlegrand.com
1.
Introduction
INSTRUCTION/INSTALLATION SHEET
CATEGORY 5 AUDIO KEYPAD VOLUME
CONTROL WITH IR
15-0313 REV. A
This Audio Keypad Volume Control with IR, PN F7394-xx (see
Figure 1), is an
integral part of the Category 5 Multi-Room Audio System. It is a component which,
when combined with other essential components and your source equipment
(receiver, CD player, etc.), creates a versatile whole-house audio system that will
fill your rooms with high-quality sound for years to come. The Category 5 Audio
technology is an innovative method of providing high quality audio to remote
locations with a single 8-conductor cable such as Category 5. This audio
technology provides many advantages over other conventional methods of audio
distribution such as simple, single Category 5 wiring scheme, infrared control of
system components, and system power status.
2. Description
There are two (2) types of Category 5 volume controls offered by On-Q Legrand.
The first type is the Amplified Volume Control (PIN F7399-IV, F7399-LA, or F7399-
WH). It has a rotary knob for volume control and offers IR control. The second type
is the Cat 5 Audio Keypad Volume Control with IR (PIN F7394-IV, F7394-LA or
F7394-WH). It has push buttons for volume control, audio source selection, and
muting. One volume control should be used for each room you choose to wire. The
volume controls are terminated with Category 5 using a
110
style punchdown block
located on the rear of the volume control.
3. Installation
8
Figure 1
Installation of the Category 5 Audio Keypad Volume Control is best accomplished at multiple times during new
construction, at "Rough-in" before the drywall is installed, and at "Trim-out" after the drywall is installed and
painted.
NOTE: Before connecting the volume controls: Make sure the power supply is not connected to the
Category 5 Audio Distribution Module. Make sure the Status input on the Single Source Input is not
connected to power. Install volume controls last so you can make any volume trim adjustments on the
volume control before installing it into the wall. For instructions on pre-wiring and installing other
components of the Category 5 Audio System, please see the Instruction Sheets included with those
components.
NOTE:
All
wiring should be terminated to the T568A wiring standard as shown in this document. Failure
to follow the correct wiring standard could result in damaged equipment.
A. "Rough-in" steps:
1) A single Category 5 cable should be run from the enclosure location to a single gang outlet box or mud
ring at each Volume Control location.
B. "Trim-out" steps:
©Copyright
2005
by On-Q/Legrand All Rights Reserved.
Page 1 of 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the F7394-xx Series and is the answer not in the manual?

Questions and answers

Related Products for On-Q/Legrand F7394-xx Series

Table of Contents