Chass global sync Instructions For Use

Radio control world travel alarm clock

Table of Contents

Download this manual

- Re-Start your clock in the flat travel position

- Make sure you have the switch on far left on USA

- The bottom switch must be in the LOCK position

- Push the tiny RESET button in with a pen or other pointy object

- Slide the bottom switch one notch to the ZONE/DST position

- Push top left ZONE button marked "12-24H/Month off-set Zone", until

your time zone appears at top of the clock front

- Push bottom switch back to the LOCK position, for the clock to

operate

It is best to not do anything to the clock, make changes, set other functions,

etc. until the clock has made the initial synchronization. You will know it has

synchronized when you see the correct Day & Date displayed on the clock.

Quick Start Steps:

Table of Contents

Do you have a question about the global sync and is the answer not in the manual?

Page 1 Quick Start Steps: - Re-Start your clock in the flat travel position - Make sure you have the switch on far left on USA - The bottom switch must be in the LOCK position - Push the tiny RESET button in with a pen or other pointy object - Slide the bottom switch one notch to the ZONE/DST position - Push top left ZONE button marked “12-24H/Month off-set Zone”, until your time zone appears at top of the clock front...
Page 2 The Global Sync takes it one step further. Until #00190 & #00191 the development of this clock, atomic clocks were able to receive and decode signals from only one transmitter.
Page 3 Note: The clock will automatically default This effect is only temporary and the numbers to Mountain Time, when the Reset button will become clear in only a few days ). These is pushed and the Switch on the Left is set batteries will last 6 months to 1 year (depending for USA.
Page 4 signal is clean and strong. If it fails for more 6. Manual Setting than 48 hours, the Antenna Icon disappears. Once it is manually set, the clock will attempt to The clock will still function as a quartz clock, synchronize regularly for 3 days. If all attempts until it gets refreshed again.
Page 5 (as proof of purchase), along with button. a brief explanation of the problem, to: The bottom switch should be put back into the LOCK position after the OFF- SET time has Hinpo-Chass, Inc. been set. 1 - H Frassetto Way Lincoln Park, NJ 07035 P.14...