Enabling And Setting The Master Code - Kwikset Smartcode 914 Programming And Troubleshooting Manual

1
Master Code
A
About the Master Code
Using a Master Code is an optional, added-security measure. It is not enabled by default. A Master Code
is used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed
as a user code, though this is not recommended). The Master Code must be 4-8 digits.
B

Enabling and Setting the Master Code

Programming timeout: If no button is pressed for five seconds, the system will time out
(indicated by three beeps and a red flashing keypad), and you will need to restart the procedure.
1. Press and HOLD the Program button until the keypad flashes green
(about 5 seconds.)
2. Enter new Master Code.
3. Press Lock button once.
Technical Support
1-866-863-6584
4. Re-enter Master Code.
5. Press Lock button once.
If programming is successful, the keypad will flash green once with
one beep.
If programming is unsuccessful, the keypad will flash red three times
with three beeps. Make sure the Master Code has not already been
programmed. Attempt the procedure again, making sure to enter the
same new Master Code in step 2 and 4.
6. Make sure switch #3 is on, and press the Program button once. If
you hear three beeps and see the keypad flash green three times, the
Master Code is enabled.
2 / 13
61883 / 01
©2014 Kwikset Corporation