Blade Not Home; Overlap; Lead Edge Sensor Blocked - Morgana AutoCreaser Pro 50 Operator's Manual

AutoCreaser Pro 50

Blade Not Home

If the machine stops and error message 04 is displayed on the touch screen, this
indicates that the lower blade / anvil has not made contact with the HOME switch.
i.e. blade still in top position. Switch the machine off and remove the blade set and
ensure that the area is free from obstructions. Return the blade set to the creasing unit
and switch the machine on. Operate the machine in the normal sequence, if the
display continues to read error message 04 it is advised to contact a Service Engineer
immediately.

Overlap

If the machine stops and error message 13 is displayed on the touch screen, this
indicates that the 'Lead Edge Sensor' has seen a sheet subsequent to the first
one as being longer. Again this could actually be a longer sheet, OR it could be a
sensor problem (if it is a recurring problem). Check that the paper gate has been set
correctly.
Lead E dge Sensor Blocked
If the machine stops and error message 60 is displayed on the touch screen, this
indicates that the lead edge sensor is blocked.
Press the system switch down and then select the right or left arrows, to inch the
paper forwards or backwards.
Press the green tick button and then press the start button.
This error message could also mean that the lead edge sensors are faulty or need
cleaning.
SYSTEM
Error Screens (Continued)
Trouble Shooting
Page 43