Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for iTaste MVP3.0
Summary of Contents for iTaste MVP3.0
- Page 1 U S E R M A N U A L U S E R M A N U A L...
- Page 2 The iTaste MVP3.0 has a variable voltage range of 3.0 – 9.0 volts adjustable in .1 volt increments and a variable wattage range of 6.0 – 30.0 Watts, adjustable in .5 watts increments.
- Page 3 The iTaste MVP3.0 uses Vrms DC current and is very accurate with a power deviation of 0.1 WARNING: Watt. The full 30 Watts is precisely maintained between resistances of 0.4 to 2.5 ohms. There Please read this section carefully to ensure you receive maximum benefits from your iTaste is no wasted power and exact accuracy means you are always vaping the power level that you MVP3.0 and enjoy vaping with it in the most safe and effective ways possible.
- Page 4 11. Obey local laws or regulations regarding Electronic Cigarettes when vaping. If you are in an area where there are any bans or potential dangers, please do not use your iTaste MVP3.0 and is not intended to treat, mitigate, prevent or cure any disease or condition. This product Advanced Personal Vaporizer.
- Page 5 Green = Almost fully Charged. When the iTaste MVP3.0 is fully recharged the LED light will power off. Yellow = Half Power. 1 Connector = Low Power. Charge the iTaste MVP3.0. 2 Firing, POWER ON, POWER OFF button 3 OELD Display Screen 4 “+”...
- Page 6 ” three times in succession to power off the iTaste MVP3.0. Always power off the iTaste MVP3.0 when it is not being used, or when it is going to be stored The iTaste MVP3.0 features automatic real-time atomizer Ohms detection. If the resistance of in a pocket, bag or purse.
- Page 7 MVP3.0. The included iTaste MVP3.0 Attach the provided EGO Thread adapter to the flush 510 connector to vape with ego style starter kit charging cable can also be used. Plug the larger USB port into the iTaste MVP3.0 and compatible tanks.
- Page 8 To POWER OFF the iTaste MVP3.0: When the iTaste MVP3.0 is in variable wattage mode press the “+” or “-” button one time and then press it again to decrease the wattage. Hold the button down to quickly increase or decrease the set wattage.
- Page 9 OLED screen. In variable voltage mode the iTaste MVP3.0 voltage can be adjusted from 3.0 to 9.0 volts in .1 We would suggest that for coil resistances of 1.7 – 2.1ohm you can begin with a setting of volt increments by pressing the “+”...
- Page 10 We strongly recommend that you are present when the device is being charged. MVP3.0 will automatically power off. Do not leave it charging unattended. When the iTaste MVP3.0 battery is fully charged the LED will power on and the device will power off.
- Page 11 Technical Specifications: Operating Voltage: 3.0V-9V Operating Wattage: 6.0W-30W Standby current: 100uA max Maximum output Wattage: 30W Maximum output Current: 10A Maximum output Voltage: 9V Clearomizer Resistance: 0.4 Ohm (minimum) Charging: Micro USB DC5V/1A OUTPUT port: DC5V/1A WARRANTY INFORMATION Innokin Technology provides a 90 day after sales service warranty to all of our authorized vendors. Please consult you’re the official Innokin website or your Authorized Innokin Technology Vendor for more information and terms of service.
Need help?
Do you have a question about the MVP3.0 and is the answer not in the manual?
Questions and answers