Dip Switch Settings - Star Micronics TSP100LAN Hardware Manual

There are DIP switches located on the bottom of the printer and various settings can be per-
formed as shown in the following table.
When changing the settings, use the following procedure.
(1) Turn the printer off and disconnect the power cable plug from the AC outlet.
(2) Remove the screw, and then remove the DIP switch cover on the bottom of the printer.
(3) Use a tool with a narrow tip to change the DIP switch settings.
(4) Install the DIP switch cover and secure it with the screw.
Note:
The new settings will take effect after the printer is turned on.
DIP Switch 1
Switch
1-1
1-2
1-3
1-4 Initializing Settings of the network *1
The factory settings of DIP Switch are all on.
*1
Initializing the network settings means deleting the set contents and restoring the network infor-
mation to factory settings. If the printer does not operate properly or if it must be connected to
a different circuit, it is recommended to initialize and reset the settings. Beware that initializing
the printer deletes all previous settings, and reverts to factory settings.
Procedure for Initializing the Network Settings
(1) Turn the printer power OFF.
(2) Turn switch 1-4 OFF, and turn the printer power ON.
(3) After approximately 15 seconds, turn the printer power OFF.

11. DIP Switch Settings

Function
Always ON
Always ON
Always ON
DIP switch1
OFF
ON
Invalid
– 31 –
ON
OFF
Should be set to ON
Should be set to ON
Should be set to ON
Valid