Always On - Bang & Olufsen Beolab transmitter 1 Installation Manual

Always On

- Disconnect the BeoLab Transmitter 1 from mains for at least 60 s.
- Insert the USB memory stick into the USB A socket
- Reconnect the BeoLab Transmitter 1 to mains
- Disconnect the BeoLab Transmitter 1 from mains for at least 60 s.
- Remove the USB memory stick
- Reconnect the BeoLab Transmitter 1 to mains
This function is made available with the SW ver. 1.1 and newer.
The BeoLab Transmitter 1 and wireless speakers are per default set to enter a standby state a while after not being actively used. When being
powered on again there is a delay before sound is heard from the speakers.
If desired it is possible to set the BeoLab Transmitter 1 to "Always On" by which the delay is reduced to about 2 s when it is desired to hear sound
from the speakers almost instantly.
Always On can be set to true or false as described in the section about Line-in setting and log files, see
A USB memory stick is needed having a file in the root with the name: WPLSETUP.TXT and this file shall contain the command line text:
ALWAYS ON:TRUE
The BeoLab Transmitter 1 restarts indicated by the product status LED being solid red
The USB memory stick must remain in the BeoLab Transmitter 1 for 10 s before being removed again.
Note: It is recommended not to set ALWAYS ON:TRUE in countries having 5 or fewer 5 GHz channels; see
Always On
page 24.
page 25.
23