Page 2
(2) I’utilisateur de I’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the user’s authority to use the equipment.
Page 3
EQ'd signal to the original signal with the push of a button. Compression keeps signals with difficult levels under control, and Peavey's exclusive guitar-shape adjusts the EQ and preamp specifically for guitar. The all new PV series mix- ers represent the pinnacle of performance and value.
Page 4
This control adjusts the level of the channel signal added to the effects mix. The signal is sent to the internal effects processor (PV6 BT) or the EFX send jack (PV6). Turning the knob to the left (min) will turn off effects on the associated channel, while turning the knob to the right will...
Page 5
This control adjusts the level of the channel signal added to the effects mix. The signal is sent to the internal effects processor (PV6 BT) or the EFX send jack (PV6). Turning the knob to the left (min) will turn off effects on the associated channel, while turning the knob to the right will increase the amount of the selected effect.
Page 6
PV 6 6 INPUT STEREO MIXER PV®6 Front Panel Two-way Audio Input Selector Allows you to select between a 1/4" and RCA audio input. ELECTRIC GUITAR PRE-SHAPE POWER TO CONTROL ROOM Balance 1/4” Adjusts relative levels of left and right channels. TO MAIN GAIN GAIN...
Page 7
PV®6 Front Panel EFX Level This is the master output level control for the EFX mix. The output level sent to the EFX Send jack is controlled by the Channel Level Control (10), the channel EFX Send controls (8), and by this master control. The 12:00 position is the recommended setting for this control.
Page 8
PV 6 BT 6 INPUT STEREO MIXER WITH DIGITAL EFFECTS AND BLUETOOTH PV®6BT Front Panel Three-way Audio Input Selector ELECTRIC GUITAR PRE-SHAPE POWER Allows you to select between a 1/4", RCA audio input, or Bluetooth TO CONTROL connection. ROOM 1/4” Bluetooth Balance TO MAIN...
Page 9
PV®6BT Front Panel RCA Connectors for Monitor Connect powered monitors, or an amplifier feeding monitor speakers here. Set the volume controls on the monitors A and B to be equal when the A/B switch is toggled. The signal sent to this output is normally the Left/Right mix. When the "To Control Room"...
PV®6 Upper Panel MAIN OUT 1/4”-Hi-Z DIGITAL STEREO EFX SEND DIRECT OUT DIRECT OUT PV 6 6 INPUT STEREO MIXER MIC/LINE INPUT This combination input jack can accept either a 1/4” (balanced or unbalanced) input or a XLR balanced, low-impedance connection. The tip is positive on the 1/4”...
Page 11
PV®6BT Upper Panel MAIN OUT 1/4”-Hi-Z DIGITAL STEREO DIRECT OUT DIRECT OUT ON/OFF PV 6 BT 6 INPUT STEREO MIXER WITH DIGITAL EFFECTS AND BLUETOOTH MIC/LINE INPUT This combination input jack can accept either a 1/4” (balanced or unbalanced) input or a XLR balanced, low-impedance connection. The tip is positive on the 1/4”...
Page 12
The USB port sends the mixer’s main/tape stereo out to the computer. The USB port receives digital audio from the computer; it can then be assigned through the USB TO Main switch ({18}, PV6; {21}, PV6BT) to the main left/right output, if the computer is being used for playback only.
Page 13
PV®6BT EFX 1 - Plate Reverb Bright 2 - Plate Reverb Medium Low-Pass 3 - Plate Reverb Dark 4 - Hall Reverb Vocal 5 - Hall Reverb Vocal Huge 6 - Hall Reverb Strings 7 - Room Reverb Vocal Air 8 - Room Reverb Snare Low 9 - Room Reverb Acoustic Guitar 10 - Delay Double...
Gain Mic Input Gain Adjustment Range: +4 dB to +59 dB Mic Input to Left/Right Balance Output 79 dB (max gain) Line Input Gain Adjustment Range: -15 dB to 40 dB Line Input to Left/Right Balance Output 60 dB (max gain) Stereo 3/4 Gain Adjustment Range: Off to +19 dB Stereo3/4 to Left/Right Output...
Page 17
7.25" wide x 11.4" deep x 2.1875" high (18.42 cm x 28.96 cm x 5.56 cm) Weight Power Requirements PV6: 3.99 lbs (1.81 kg) 100-240 VAC 50/60 Hz 15 Watts PV6BT: 4.06 lbs (1.84 kg) Installation Note: This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"...
Page 18
What Peavey Will Do We will repair or replace (at Peavey’s discretion) products covered by Warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for Warranty service, the consumer must pay initial shipping charges. If the repairs are covered by Warranty, Peavey will pay the return shipping charges.
Need help?
Do you have a question about the PV6 and is the answer not in the manual?
Questions and answers
I just bought this today, how can I get the software?