Yamaha CD-S2000 User Manual page 21

Refer to the chart below if this unit does not function properly. (fthe problem you are experiencing is not listed below or
if the instructions below do not help, turn off this unit, disconnect the AC power cable, and contact the nearest authorized
Yamaha dealer or service center.
Problem Cause
Remedy
See
page
The unit does not The power cord is not connected nor completely Securely connect the power cord.
switch ON when
connected.
16
POWER is pressed
upward.
The disc tray does not
A foreign object is obstructing the tray. Carefully check the disc tray and remove the
-
close completely. foreign object.
Playback does not
The disc is damaged. Check the disc carefully; replace it if necessary. -
start.
There is moisture on the laser pickup. Wait 20 to 30 minutes after switching the unit
-
ON before trying to play back a disc.
The disc is loaded upside down. Reload the disc with the label side up. -
The disc is dirty. Clean the disc. -
The MP3 or WMA formats are not compatible Replace the disc with a correctly recorded disc
20
with this unit.
playable with this unit.
The CD-RW (ReWritable) disc is not recorded Replace the disc with a correctly recorded disc
-
correctly. playable with this unit.
The disc is a non-standard disc not playable with Replace the disc with a correctly recorded disc
-
this unit. playable with this unit.
Playback is delayed,
The disc may be scratched or damaged. Check the disc carefully; replace it if necessary.
or begins at the -
wrong place.
No sound.
Improper output cable connections. Connect the cables properly. If the problem
14
persists, the cables may be defective.
Improper amplifier operation. Set the amplifier controls to the correct input
-
selection.
Sound "skips". This unit is being subjected to vibrations or Relocate this unit.
impacts.
-
The disc is dirty. Clean the disc.
-
Sound "hums".
Improper cable connections. Securely connect the audio cables. If the problem
14
persists, the cables may be defective.
Noise from a nearby The tuner is too close to this unit. Move the tuner and this unit farther apart.
tuner.
-
Noise from inside of The disc may be warped. Replace the disc.
the disc tray.
-
The remote control
The batteries of the remote control are too weak. Replace the batteries with new ones.
12
does not work.
Remote control is too far away or tilted too Use within 6 m and 60° radius.
12
much.
Direct sunlight or lighting (of an inverter type Reposition this unit.
fluorescent lamp etc.) is striking the remote
12
control sensor of this unit.
21
En
•