Panasonic KX-A406 Installation Manual page 20

1. Linking to Cell Stations
PROBLEM
R The repeater
cannot be
registered in Easy
Registration mode.
(The process keeps
repeating
automatically.)
R The repeater
cannot be
registered in
Manual
Registration mode.
(The process keeps
repeating
automatically.)
R The repeater's
STATUS indicator
and RSSI/ID
indicator flash
green and red
alternately (alarm
indication).
R The PS is beeping.
R Poor audio quality.
20
PROBABLE CAUSE
R The CS is out of range.
R The CS is not turned on.
R The destination repeater is
not turned on.
R The selected ID does not
match the ID of the
destination repeater.
R The ID of the repeater is the
same as the ID of another
repeater (including cascade
configuration repeaters)
that is registered to the
same CS.
R The verification tone is
turned on.
R The CS is out of range.
R The PS is out of range.
SOLUTION
R Move the repeater closer to the CS.
R Confirm that the CS is on.
R Confirm that the destination repeater is on.
R Follow the procedure below to change the
selected ID.
1. Check the ID of the destination
repeater in ID Confirmation mode (refer
to "ID Confirmation/Verification Tone
Mode").
2. Enter Manual Registration mode by
pressing and holding down the
PROGRAM button of the repeater for 5
seconds while the repeater's STATUS
indicator is flashing red, and releasing it.
3. Select the ID that matches the
destination repeater in manual
registration again (refer to "Manual
Registration").
R Follow the procedure below to change the
ID of the repeater.
1. Press the PROGRAM button to cancel
the alarm indication of the repeater.
The repeater will enter ID Confirmation
mode.
2. Check the IDs of the repeater and the
other repeater that is registered to the
same CS, in ID Confirmation mode
(refer to "ID Confirmation/Verification
Tone Mode").
3. Enter ID Modification mode by pressing
and holding down the PROGRAM
button of the repeater for 5 seconds
and releasing it.
4. Change the ID of the repeater so as
not to overlap with the ID of the other
repeater in ID Modification mode (refer
to "ID Modification").
R Turn the verification tone off (refer to "ID
Confirmation/Verification Tone Mode").
R Move the repeater closer to the CS.
R Move the PS closer to the repeater.