Download Print this page

Nemo NE4380 Assembly Instructions Manual

Nemo automatic pool cleane

Advertisement

Quick Links

ABOVE-GROUND POOL CLEANER

ASSEMBLY INSTRUCTIONS

Congratulations on purchasing a
Nemo Automatic Pool Cleaner!
MODEL NE4380

Advertisement

loading
Need help?

Need help?

Do you have a question about the NE4380 and is the answer not in the manual?

Questions and answers

Summary of Contents for Nemo NE4380

  • Page 1: Assembly Instructions

    ABOVE-GROUND POOL CLEANER ASSEMBLY INSTRUCTIONS Congratulations on purchasing a Nemo Automatic Pool Cleaner! MODEL NE4380...
  • Page 2 NE4380 PARTS LIST Re f. # Orde r # De scri ption NEP2276 Body NEP2277 Dive Float Restrictor NEP2278 Eyeball Diverter & Out Ring NEP2279 Hose Weights (3 pack) NEP2280 Auto Regulator Valve NEP2281 Hose Cone NEP2282 Roller Bumper Strap...
  • Page 3 ATTACH THE SEAL To install the seal locate the word “UP”. Face it up towards the body of the cleaner. Gently stretch the seal over the foot pad of the cleaner until it sets itself into the groove as illustrated in gure 2.
  • Page 4 ASSEMBLE THE HOSE Your cleaner hose comes in 3’ sections which must be connected together. The hoses are connected by inserting the male cu of one section of hose into the female cu of another. Twist the sections of hose together until you establish a snug t (See gure 5).
  • Page 5 Once fully assembled, your Automatic Pool Cleaner should look like this..Your automatic pool cleaner is designed to work in a wide variety of swimming pools. There are items that may or may not be needed to be installed for your cleaner to function properly.
  • Page 6: Helpful Hints

    You may also need to attach hose weights to neutralize the hose’s buoyancy in the water. For aboveground pools with the at bottoms, typically one weight is needed. It should be placed on the rst section of hose, between 4 to 12 inches away from the body’s swivel head.
  • Page 7 If debris is still lodged inside the cleaner, you must remove the apper. To do this you must take out the four red plugs in the foot pad. These are found on the bottom of the cleaner. They can be removed using a at head screwdriver. Underneath there will be four screws.
  • Page 8: Troubleshooting

    POSSIBLE CAUSE SOLUTION PROBLEM 1. Vacuum moves too • Filter is dirty. • Backwash or clean slow or not at all element. • Skimmer or pump strainer baskets are clogged with • Empty baskets out. debris. • Turn cleaner over and •...