Page 1
6730 classic RM-547 RM-566 Service Manual Level 1&2 SERVICE MANUAL Level 1&2 NOTE: This product is not Transceiver characteristics publicly launched. Until the Band: launch, this is a secret GSM/EDGE RM-547, RM-566: product. 850/900/1800/1900 WCDMA 900/2100 Display: 2.2” QVGA TFT display (240 x 320 pixels), active area 33.5 mm x 44.6 mm, up to 16 M...
15.05.2009 First approved version The purpose of this document is to help NOKIA service levels 1 and 2 workshop technicians to carry out service to NOKIA products. This Service Manual is to be used only by authorized NOKIA service suppliers, and the content of it is confidential. Please note that NOKIA provides also other guidance documents (e.g.
Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.
6730 classic RM-547 RM-566 Service Manual Level 1&2 3. WARNINGS AND CAUTIONS Please refer to the phone’s user guide for instructions relating to operation, care and maintenance including important safety information. Note also the following: 3.1 Warnings 1. CARE MUST BE TAKEN ON INSTALLATION IN VEHICLES FITTED WITH ELECTRONIC ENGINE MANAGEMENT SYSTEMS AND ANTI–SKID BRAKING SYSTEMS.
6730 classic RM-547 RM-566 Service Manual Level 1&2 4. ESD PROTECTION Nokia requires that service points have sufficient ESD protection (against static electricity) when servicing the phone. Any product of which the covers are removed must be handled with ESD protection.
6730 classic RM-547 RM-566 Service Manual Level 1&2 5. CARE AND MAINTENANCE This product is of superior design and craftsmanship and should be treated with care. The suggestions below will help you to fulfil any warranty obligations and to enjoy this product for many years.
6730 classic RM-547 RM-566 Service Manual Level 1&2 6. BATTERY INFORMATION Note: A new battery’s full performance is achieved only after two or three complete charge and discharge cycles! The battery can be charged and discharged hundreds of times but it will eventually wear out.
6730 classic RM-547 RM-566 Service Manual Level 1&2 8. SERVICE DEVICES RJ-230 Universal soldering jig FLS-5 Flash device BL-5CT internal battery SS-88 Camera removal tool NMP standard toolkit (v2) For more information, refer to the Service Bulletin (SB-011) on NOKIA Online.
6730 classic RM-547 RM-566 Service Manual Level 1&2 10. DISASSEMBLY INSTRUCTIONS 10. DISASSEMBLY INSTRUCTIONS 1) Open the BATTERY COVER by lightly pressing it 2) Remove the BATTERY COVER. with your thumbs and sliding the cover as shown. 3) Remove the battery.
Page 13
6730 classic RM-547 RM-566 Service Manual Level 1&2 7) Protect the A-COVER ASSEMBLY window with 8a) Work the tool around the A-COVER ASSEMBLY protective film. Carefully wedge the SRT-6 tool to release the clips. between the A-COVER ASSEMBLY and the B-COVER.
Page 14
6730 classic RM-547 RM-566 Service Manual Level 1&2 12) Remove the B-COVER. 13) Use the SS-93 tool and carefully release the UI CONNECTOR. 14) Use the SRT-6 to carefully lift the LIGHT SWAP 15) Lift the LIGHT SWAP PWB as shown.
Page 15
6730 classic RM-547 RM-566 Service Manual Level 1&2 18) Carefully remove the LCD. 19) Use the tweezers to release the CAMERA BOOT. 20) Remove the CAMERA BOOT. 21) Use the SS-88 tool to release the CAMERA. Lift and remove the CAMERA.
Page 16
6730 classic RM-547 RM-566 Service Manual Level 1&2 24) Remove the ANTENNA ASSY. 25) Release the CONN AV 4POL D2.5. 26) Remove the CONN AV 4POL D2.5. 27) Use the charger plug to release the CONN CHR DIA 2.0MM COMPRESS.
Page 17
6730 classic RM-547 RM-566 Service Manual Level 1&2 30) Remove the T9 KEYMAT. Do not use this part 31) Use the dental tool to release the EARPIECE. again. 32) Remove the EARPIECE. Do not use this part 33) Use the dental tool to release the adhesive again.