Initial Setup; Clock Setting; Display Brightness - Sharper Image 203662 Manual

INITIAL SETUP

• Plug the AC adapter into the jack on the back of the unit,
then plug into an AC outlet.
• One CR2032 button cell battery is included. Remove the
battery compartment door and remove the plastic strip to
activate the battery.

CLOCK SETTING

After power on, your clock is now in clock display mode
• Press and hold [SET] to enter clock setting mode and set
the following 12/24 hour format > Hour > Minute > Exit
• Press [Vol +] or [Vol -] button to adjust setting and press
[SET] to confirm each setting

DISPLAY BRIGHTNESS

• Use the [DISPLAY OFF/LO/HI] slide switch to adjust the
orange display brightness or turn off the display
• When [DISPLAY OFF] is selected, press [SNOOZE/LIGHT]
will turn on display for 10 seconds
LED LIGHT BOX
• Press the top [SNOOZE/LIGHT] will turn on white light
gradually
• To adjust the light box brightness, press [LIGHT +] or
[LIGHT -] button to select between
1 to 18 brightness level
• - Press [SNOOZE/LIGHT] again to turn off the
light gradually