Digi Link Iii System Remote Controls - Sherwood RD-7500 Operating Instructions Manual

DIGI LINK III System Remote Controls

• You can remotely control not only this receiver but also Sherwood compatible components bearing the DIGI LINK II or III
logo.
• For system remote control operation, first make the DIGI LINK connections.
• In the DIGI LINK III remote control system, if pressing PLAY, etc. on CD player or tape deck, CD or TAPE is selected
automatically without selecting the input source and then PLAY, etc. starts.
Notes:
• Some functions for a CD player or tape deck may not be available.
• For details about functions, refer to the operating instructions of each component.
Input Selector buttons
In the standby mode,
when presing an input selector button,
the unit is turned on automatically and
the desired input source is selected.
CD player section
REPEAT A<>B - to play a specific part repeatedly
/ - to skip backward or forward
INTRO - to preview each track only for 10 seconds
DSP mode UP/DOWN (
CHannel SELector button
Channel LEVEL up/down(+/-) buttons
SPeaKer SETup button
ADJUST up/down( / ) buttons
POWER
POWER button
TUNER
VIDEO1
- to begin play
- to pause play
- to stop play
A
DECK SEL
B
/ ) buttons
AUTO
AUTO button
MUTE
MUTE button
LEVEL
SLEEP
SLEEP button
1
6
STANDBY
STANDBY button
CD AUX TAPE
VIDEO2 VIDEO3 7CH DIR
REPEAT
P .SCAN
Preset SCAN button
< <
A B
CD
INTRO
TAPE deck section
DECK SELECTOR A, B - for selecting deck A or B
TAPE
DSP
STEREO
STEREO button
T.TONE
Test TONE button
Master volume up/down(
VOL.
LEVEL
CH.SEL
DIMMER
VOL.
DIMMER button
SPK SET PL II PARA
PL II music PARAmeter button
ADJUST ENTER
ENTER button
Numeric(1~0) buttons
2 3 4 5
7 8 9 0
11
- to begin reverse or forward side playback
/
- to wind up the tape reversely or forwardly
/
- for recording
- to stop playback or recording
/ ) buttons