Toshiba GL-1010 Administrator's Manual page 144

Configuring AppleTalk Settings
If you are using the AppleTalk networking protocol for any wireless
network traffic involving the controller, you must enable the AppleTalk
protocol on the wireless NIC. The AppleTalk protocol is enabled by
default. If you are not using AppleTalk for any wireless network traffic,
disabling the AppleTalk protocol on the wireless NIC reduces overhead
and improves efficiency.
1 Log in as an administrator.
2 On the Administration tab, click the
3 Click the
4 In the AppleTalk area, click the
5 Select
6 Enter the
7 Click
Configuring the Wireless NIC Settings
If you are using the wireless network for any network traffic involving the
controller, you must enable the wireless NIC on the controller. The
wireless NIC is enabled by default. If you are not using the wireless
network for any network traffic, disabling the wireless NIC on the
controller reduces overhead and improves efficiency.
1 Log in as an administrator.
2 On the Administration tab, click the
3 Click the
4 In the General area, enter the controller
5 Select the
6 If required, check
WEP Key
7 Select the type of
8 Enter the
9 Select the
10 Enter the identifier for the
characters (
11 Enter the
12 Select the
122
Wireless Network
to enable AppleTalk.
Enable
AppleTalk Zone
.
Save
Wireless Network
from the drop-down list.
Network Type
Use WEP Security
, and
Authentication
WEP Encryption
as 5 or 13 sets of hexadecimal characters.
WEP Key
Authentication
Infrastructure
number (
Channel
Transmit Power
Setup
link. The Wireless Network page opens.
drop-down list.
Protocol
string.
Setup
link. The Wireless Network page opens.
and
Set WEP key
fields are enabled.
from the drop-down list box.
mode from the drop-down list box.
Default Access Point
network type only).
network type only).
Ad Hoc
from the drop-down list box.
GL-10x0
subtab.
subtab.
.
SSID
. The
WEP Encryption
as 6 sets of hexadecimal
Administrator's Guide
,