Check Brake Fluid Level; Drain Fuel System Water Separator - New Holland T6010 Operator's Manual

OPERATION 2

CHECK BRAKE FLUID LEVEL

If the indicator light on the instrument panel signals
low brake fluid, check the level in the reservoir.
The reservoir is located under the rear of the hood on
the right-hand side and supplies fluid to the rear
brakes and front brakes (where fitted).Visually check
the level of fluid in the reservoir. It should never be
allowed to fall below the 'MIN' line (3) moulded into
the bottle. If necessary, remove the filler cap (1) and
top up with the correct brake/clutch mineral oil to the
'MAX' line (2). Do not overfill. Tractors with 12 x 12
transmission have
reservoir. The reservoir on all other models is for the
brakes only.
IMPORTANT: Take care not to spill brake fluid on the
tractor as it may damage the paintwork.
WARNING
Use only the correct type of brake/clutch mineral oil.
Mixing different types of fluid may cause damage to
internal hydraulic braking components and result in
brake failure. Adhere to the instrutions on the brake
fluid container. See page 4--9 for correct brake fluid
specification.
OPERATION 3
DRAIN FUEL SYSTEM WATER
SEPARATOR
IMPORTANT: Before loosening or disconnecting
any part of the fuel injection system, thoroughly clean
the area to be worked on to prevent contamination.
If the indicator light on the instrument panel signals
the presence of water in the fuel sedimenter,
immediately drain the fuel filter and sedimenter
assembly as follows:
1. Remove the sensor wire from the drain plug
2. Open the drain plug on the sedimenter by
loosening the knob.
3. Allow contaminated fuel to drain until only clean
fuel runs out. Catch the fuel in a suitable
container and dispose of properly. Close the
drain plug and replace the sensor wire.
SECTION 4 - - LUBRICATION AND MAINTENANCE
a combined brake/clutch
15
16
4--13