Table of Contents
Advertisement
Quick Links
Linksys RV042 Setup
1. Obtain the following information from your internet service provider:
• IP address
• Subnet mask
• Default gateway
• DNS server address(es).
2. Connect port 1 of the VPN router to the elevator LAN (typically to an available port on
the LAN switch of the iCentral).
Note
If the iCentral contains a hub instead of a switch, connect the cable to the last
available port on the hub and make sure the switch is in the "uplink" or "cross-
over" position.) You should see a light on both the VPN router and the LAN switch for the
connected ports.
3. Connect an Ethernet cable from an available port of your DSL/Cable Modem to the
Internet port of the VPN router.
4. Connect the included AC power adapter to the VPN router and plug it in.
Instruction # 42-IS-0160, Rev A1. Copyright 2008, Motion Control Engineering.
• Linksys RV042 Setup
VPN Router Setup
1
Advertisement
Table of Contents
Related Manuals for Cisco Linksys RV042
Summary of Contents for Cisco Linksys RV042
- Page 1 • Linksys RV042 Setup VPN Router Setup Linksys RV042 Setup 1. Obtain the following information from your internet service provider: • IP address • Subnet mask • Default gateway • DNS server address(es). 2. Connect port 1 of the VPN router to the elevator LAN (typically to an available port on the LAN switch of the iCentral).
- Page 2 5. Using the iView computer, go to Start > Control Panel > Network connections. Right click the LAN Ethernet connection and click Properties. 6. Double-click on Internet Protocol (TCP/IP). Write down your current IP settings. You will need to re-enter them in a later step. 7.
- Page 3 Linksys RV042 Setup 10. Enter 192.168.1.1 into the address bar. 11. A screen will appear and ask for the user name and password. Enter admin in the User Name and password fields. Click OK. 12. You will now see the router configuration screen. Click the Setup tab.
- Page 4 16. Fill-in the IP address, subnet mask, default gateway address and DNS server address(es). 17. Click Save settings on the bottom of the screen. 18. Power cycle the DSL/Cable modem. Typically this can be accomplished by unplugging the unit and waiting until the lights turn off, then plugging it back in. 19.
- Page 5 Linksys RV042 Setup 21. Click the System Management Tab, then click the diagnostic tab below. Type www.google.com into the Ping host or IP address. Click Go. After a few moments the screen should show Test Succeeded. If the test fails, double-check the VPN routers IP address settings and cable connections.
- Page 6 25. Create a new user account. For user name use mcesupport and password mcesup- port. Click the Add to list button. 26. Click Save settings at the bottom of the screen. 27. Click the Setup tab, then click Password below. Type in admin for the Old Password field and mcesupport for the New Password and Confirm New Password fields.
Need help?
Do you have a question about the Linksys RV042 and is the answer not in the manual?
Questions and answers