Charging Nicd/Nimh Battery In Re-Peak Charge Mode; Charge/Discharge & Discharge/Charge Cycle Of Nimh/Nicd Battery; Battery Memory Set - Skyrc QUATTRO B6AC Instruction Manual

NIMH/NICD BATTERY PROGRAM

CHARGING NICD/NIMH BATTERY IN RE-PEAK CHARGE MODE

Re-peak Charge Mode (NiCd and NiMH batteries only): In re-peak charge mode, the
charger can peak charge the battery once, twice or three times in a row automatically. This
is good for confirming the battery is fully charged, and for checking how well the battery
receives fast charges. A five minute cool-off delay occurs after each re-peak charge. See
the diagram below for using re-peak charge mode. To start charging, press the Start/Enter
button for 3 seconds.
N i M H R E - P E A K
ENTER/START
N i M H 2 . 0 A 9 . 5 9 V
R P C 0 0 0 : 3 3 0 0 0 1 7
CHARGE/DISCHARGE & DISCHARGE/CHARGE CYCLE OF NIMH/NICD BATTERY
NiMH CYCLE
CHG＞DCHG
-
+
DEC INC DEC
Batt type Start
'> 3 seconds '
Stop Enter
NiMH 1.0A 7.42V
C>D 022:45 00890
Elapsed Battery
Battery
time voltage
type
Discharge
or charge
current

BATTERY MEMORY SET

The charger can store up to 10 different charge/discharge profiles for your convenience,
and the stored profiles can be recalled quickly without having to go through the setup
process.
BATT MEMORY【1】
ENTER SET
ENTER
＞3 seconds
START
BATT TYPE
LiPo
DEC INC
"Re-peak cycle: 1" shows on the display. Press the
button to make the re-peak cycle number blink and press the
1
Dec/Inc button to find the desired number of times to re-peak.
Press the Start/Enter button to confirm selection.
You can set up sequence on the left and the number of cycles on
1
the right. Range of the cycle number is 1-5.
-
+
INC
Press Batt Type/Stop key to stop program, you can press
Start/Enter key to alter charge current. The sound indicates the
end of program.
Discharged
or charged
capacity
Enter the battery memory program, you can change the battery
type(Lipo, Lilo, LiFe, NiMH, NiCd, Pb battery), voltage, charge
current by pressing the Start/Enter button to make the value blink,
the INC or DEC buttons to change the value, and Start/Enter button
once more to store the value and move to the next value or screen.
(Note: The battery used for this example is a 2S(7.4V) Lipo battery.
Start/Enter