Service Mode; Service Mode Entry And Exit - Philips B8 Series Service Manual

When the correct position is located, place wedges 2 and 3 as seen in Figure B or E of
the
6. Now remove wedge 1 and place it as shown in Figure C or F.
7. Set the green control back to its mid-range position.
8. Proceed to the White Balance procedure.

SERVICE MODE

Note: Many of the following adjustments are made through software intervention. A
Remote Transmitter is required in order to modify register values stored within the
EEPROM IC on the Main Chassis Board.
The G96SVC Service Remote is an ideal tool for this purpose. Order 4835 219 17656.
The service mode makes it possible to change the values of special memory registers in
the EEPROM IC (IC302). These registers affect the customer adjustments and other
functions. These registers also make many other service adjustments possible that
previously would have been handled by conventional controls mounted on the P.C.
Board.

Service Mode Entry and Exit:

Using the remote transmitter, enter the following seven-button sequence to activate the
Service Mode:
06-25-96-Menu
Note: This sequence must be entered consecutively without allowing the on screen
display to time out between entries.
Exit Service Mode
To exit the Service Test Mode procedure enter Service Page I and press the Volume Up
button on the remote transmitter.