Beep sound
Long beep (1.5 sec)
Use the LCD Panel
You can use the LCD panel to perform disk configuration and view the system information.
When the NAS has started up, you will be able to view the NAS name and IP address:
N A S 5 F 4 D E 3
1 6 9 . 2 5 4 . 1 0 0 . 1 0 0
For the first time installation, the LCD panel shows the number of hard drives detected and the IP
address. You may select to configure the hard drives.
Number of
Default disk
hard drives
configuration
detected
1
Single
2
RAID 1
3
RAID 5
4 or above
RAID 5
Press the Select button to choose the option.
i
Press the Enter button to confirm.
For example, when you switch on the NAS with 5 hard disks installed, the following message is
displayed on the LCD panel:
C o n f i g . D i s k s ?
Fujitsu
No. of Times
2
1
Available disk configuration options
Single
Single JBOD RAID 0 RAID 1
Single JBOD RAID 0 RAID 5
Single JBOD RAID 0 RAID 5 RAID 6 RAID 10
Description
●
The disk volume is going to be full.
●
The disk volume has reached its full
capacity.
●
The hard disk drives on the NAS are in
degraded mode.
●
The user starts hard drive rebuilding.
●
The NAS is turned off by force shutdown
(hardware shutdown).
●
The NAS has been turned on and is
ready.
Installing the NAS
13