Strong PrimaSat II User Manual page 15

5.4.5 Set Default
Press pq to select Set Default and press OK.
A pop-up screen will ask you: "Set factory default?". Press OK or ExIT.
Please be careful when using this function, as it will erase all the data and parameters you may have set
earlier. Once you have set to Default you will have to re-install your preferences and re-scan channels. The
receiver will return to its factory default state and all user data will be deleted.
Before you set to Default, make a backup on a USB Device! (Chapter 5.4.6.3 Backup to
NOTE:
USB.)
NOTE: Your PIN code will change back to the factory setting "0000".
5.4.6 SW Update
Press pq to select SW Update and press OK.
Use pq to move to the following sub-menus Update by OTA, Update by USB, Backup to USB.
5.4.6.1 Update by OTA
This function will search for new software on satellite.
An Update by OTA menu will pop up and you can edit this menu with pqtu and the numeric buttons
to change the details. Press OK to scan directly.
For OTA you can set Enabled and Disabled.
Default: It will scan at this default setting for new software.
Change OTA to Disabled if you don't want to use this function.
Note: Needed parameters can be changed. Please ask your local STRONG dealer in case
software update was not successful.
Warning! During the Update process NEVER disconnect the receiver from the main or disconnect
the receiver from the antenna cable! This can damage your receiver and warranty will be
void! After the update the receiver restarts automatically!
5.4.6.2 Update by USb
a)
b)
c)
An Update Files list will pop-up and you can use pq tu to highlight the software you want to load.
Press OK and confirm the new request "System Update?" and press OK for Yes or ExIT for exit.
12
Download the required update file for your receiver model from our website
www.strong.tv.
Unzip the file, copy it to your USB device and connect it to the USB port of
your receiver.
Use pq to move to Update by USB and press OK. (USB device should be
connected!)
PART 1 • English