Replacing The Tires On The Cleaner - Zodiac Vortex 3 Owner's Manual

Page 16
ENGLISH
Figure 34. Cut Tabs
6. Repeat this procedure to install the second
brush.
5.4

Replacing the Tires on the Cleaner

1. Pull on the inside of the old tire to remove the
tire lip from the wheel. See Figure 35.
Figure 35. Pull the Old Tire Over the Wheel
2. Remove the old tire as shown in Figure 36.
Figure 36. Remove the Old Tire
3. To replace the tire, position the tire on the wheel
making sure to orient the tire so that the word
INSIDE is toward the body of the cleaner. See
Figure 37.
Zodiac Vortex™ 3, Vortex 4 Robotic Pool Cleaner
®
1
2
|
Owner's Manual
1
Towards
Body
Figure 37. Tire Replacement Orientation
4. Push one side of the tire on to the wheel and fit
the rib of the tire in the groove of the wheel as
shown in Figure 38.
Figure 38. start on One side of the Tire
5. Work the tire onto the wheel and verify the
rib of the tire is positioned properly within the
groove of the wheel. Refer to Figure 39
Figure 39. Work the Tire On Around the Wheel
6. Push and position the rib of the inner side of the
tire in the groove of the wheel. Refer to Figure
40. If needed, turn the wheel gently to help
with installation.
2
3