Table of Contents
Advertisement
BATTERY CHARGER
SPECIFICATIONS
80V charger: 2901402
Input: 120VAC, 60Hz, Max. 5A
Output: 80VDC
Weight: 3.3 lbs (1.5kg)
CHARGING PROCEDURE
The battery is not shipped fully charged. It is recommended to fully charge before first use
NOTE:
to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory
and may be charged at any time.
A fully discharged battery pack will require approximately 30 minutes to fully charge from a discharged
state. Plug the charger into an AC power outlet.
Insert the battery into the charger.
•
This is a diagnostic charger. The Charger LED Lights will illuminate in specific order to communicate
the current battery status. They are as follows:
False defect note:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery from
the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is properly
charging. If the status LED is still blinking RED, remove the battery and unplug the charger for 1 minute.
After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks GREEN, then the
battery is properly charging. If the status LED is still blinking RED, the battery is defective and needs to
be replaced.
Charging
Charged
LED STATUS
Blinking Green
Solid Green
Solid Red
Blinking Red
Fully
Over
Temperature
DESCRIPTION
Charging
Fully Charged
Over Temperature
Charging Fault
4
Charging
Fault
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 2901302 and is the answer not in the manual?
Questions and answers
what does the red light on the charger indicate? why does the weed eater run for a minute or two and then shut off?
The red light on the GreenWorks charger indicates that the battery is either warm or not charging properly. If the red light stays on, allow the battery to cool inside the charger for up to 30 minutes. Charging should start automatically once the battery cools.
If the GreenWorks weed eater runs for a minute or two and then shuts off, it may be due to a defective or undercharged battery. Check the battery's charge level using the battery capacity indicator. If the battery shows less than one green light or no lights, it needs to be charged. If the battery does not charge and the LED blinks red, the battery is defective and needs replacement.
This answer is automatically generated
Battertt will only use one light, two remain on