Ethernet Configuration; Figure 4-18 Ethernet Configuration Screen - NEC ElectraElite IPK II Installation Manual

Electra Elite IPK II
___________________________________________________________________________________
Domain Name: The domain name of the CNF(16)-U20 ETU.
Nameserver Address: The IP address of the nameserver to be used.
DHCP: If Enabled, DHCP is used to obtain the TCP/IP information.
6.1
___________________________________________________________________________________
Multimedia Conference Bridge Installation Manual

Ethernet Configuration

The Ethernet Interface setting allows for manual configuration of the Ethernet
port speed and Mode. The ethernet interface can support 10MB or 100MB
speed, and Full-Duplex or Half-Duplex mode setting (at default, this will be set
to Auto Negotiate). When set to Auto Negotiate, the CNF(16)-U20 ETU will
sense the peer connection (wherever the cable is connected to (e.g. Hub,
Switch, or Router) hardware capabilities and negotiate the best possible
speed and operation mode.
The new settings to the ethernet port are effective immediately after clicking
"Submit."

Make sure that the peer (the other side of the Ethernet cable) is capable of Auto
Negotiate (some Routers may not have this feature).

Figure 4-18 Ethernet Configuration Screen

Document Revision 1A
4 - 21