Table of Contents
Advertisement
Battery Power
Remaining Battery
Tap
The remaining battery charge is displayed.
When the Remaining Battery Charge Becomes Low
Option Button
Replacing the Battery Pack
When the charge provided by your battery pack is supplied for only a short period of time,
even after full charging according to the instructions, it may be time to replace your battery
pack. The battery pack is a consumable item and therefore requires replacement (CF-VZSU28).
Replace the battery pack within 3 hours; otherwise the data in RAM will be lost.
- [Settings] - [System] tab - [Power].
Plug in the AC adaptor, and fully charge your battery.
Use a spare battery if you have one.
If you have neither the AC adaptor nor a spare battery, power off your computer.
CAUTION
Do not touch the terminals of the battery pack. The battery pack may no longer function
properly if the contacts are dirty or damaged.
Do not expose the battery pack to water, or allow it to become wet.
The battery pack is not charged when CF-P1 is first purchased. Be sure to charge it
before using it for the first time. When the AC adaptor is connected to CF-P1, charging
begins automatically.
Use only the specified battery pack (CF-VZSU28) with CF-P1.
Do not install or remove the battery pack while CF-P1 is on.
If the computer does not turn on after changing the battery pack, push the reset switch.
Remove the battery pack
(1) Power off your computer.
(2) Turn your computer over.
(3) Press position (A) to depress the battery pack cover
and then slide the latch, and remove the battery pack
cover.
NOTE
If the attached strap makes it difficult to remove the
battery pack cover, unbuckle the strap and then re-
move the cover.
(4) Remove the battery in the direction shown in the figure.
Install the battery pack
Refer to page12 about installing the battery pack.
Battery Pack Cover
Latch
(A)
27
Advertisement
Table of Contents
