HPI Racing SAVAGE Flux HP Instruction Manual page 12

5
ESC Setup
You must setup the ESC before running the first time. After the initial setup, it is not required before every run.
Please read through the instructions and get familiar with the procedure before starting setup. The setup process moves quickly,
and it will help you to be ready for each step.
Before Setup
We strongly recommend removing your tires before calibration as a safety precaution!
Start with the transmitter ON and the ESC switched OFF. Adjust the throttle trim to the center position.
1
Z260
86804
8
mm
Installation is reverse of removal.
Setup
En
Make sure the transmitter on. You will hear a short series
Hold Full throttle while of tones followed by a two
switching on esc second pause, followed by
a long series of tones.
ON
LED GREEN
ON
LED
Setup Confirmation
If the LED on the speed control does not work as shown below, the speed control may not be setup properly. Repeat the setup process.
Full Throttle LED (Green) Lighting
2
Z680
x4
M5x6mm
87546
Glow Plug Wrench
Move trigger to full brake
position and hold until you
hear a long series of tones.
RED RED
Neutral
3
OFF
ON
Release trigger allowing it
to return to neutral position.
YELLOW YELLOW
LED (Yellow) Lighting
12
Deutsch
P.13 Français
LED
Throttle Trim
Center
You will hear a long series
of tones followed by a two
second pause, followed by
a short series of tones.
ALL YELLOW
Full Brake LED (Red) Lighting