Table of Contents
Advertisement
1
1
Keep your face and décolleté (breast) at least
20 cm away from the edge of the nozzle cap
(25 cm away from the steam outlet).
●
When using the appliance for the first time or it is
difficult to find the appropriate distance, use the
attached leaflet to confirm the distance between the
area you want to expose to the steam and the nozzle
cap edge.
2
2
To use the steam for your entire face, position
the nozzle toward your face slightly above the
chin.
3
3
After use, wipe off any water with a towel or tissue, and then
apply lotion to prepare your face and apply an emulsion to
supplement skin oil.
●
If you do not use any skin care products after using the appliance, moisture
on your skin will evaporate, and the skin surface becomes dry.
How to use the cool mist (micro mist)
●
Release of mist is slightly uneven and the sound (steam release) may fluctuate.
This is normal.
Prepare a towel or tissue to use the mist on your face. Since the size of the
particles of mist is larger, your face, clothes, and the surrounding area may get
wet.
Portion
Use the mist on any areas of concern on your face and chin.
Maintain the same distance with the mist as when using the
steam.
●
If water droplets on your face are uncomfortable, wipe them
off with a towel.
●
When using the mist on your chin, your clothes may get wet.
Cover your clothes with a towel or take other precautions to
avoid getting wet.
8-9
Lamp indication/blinking
HOT STEAM (hot steam) lamp/COOL MIST (cool mist) lamp
●
When the HOT STEAM (hot steam) lamp
turns on, the steam is released.
冷喷雾
●
When the COOL MIST (cool mist) lamp
净 肤
控 油
turns on, the mist is released.
Problem notification function of the course indication lamps
If the following lamp indications are generated, follow the directions for the remedy
listed in the table below.
Lamp indication
Causes
The appliance is inclined.
All of the course
(The appliance may be
indication lamps are
set on a waterproof
blinking.
sheet.)
The HOT STEAM (hot
No water.
steam) lamp is blinking.
The HOT STEAM (hot
The steam stops.
steam) lamp and the
Under preparation.
COURSE 1 lamp are
blinking.
The COOL MIST (cool
The supplied water is too
mist) lamp is blinking.
cold.
Abnormal conditions on
All lamps are blinking.
the appliance.
Remedy
Set the appliance on a
flat surface.
Supply the water.
Let the appliance stand
until the HOT STEAM
(hot steam) lamp turns
off.
(The steam is released
continuously.)
Select a course again to
start the operation.
Contact an authorized
service center when the
COOL MIST (cool mist)
lamp often blinks.
Contact an authorized
service center.
2008/01/19
13:21:55
Advertisement
Table of Contents
