Lenovo ThinkVision L190 User Manual

Lenovo ThinkVision L190 User Manual

Lenovo tft lcd color monitor user's guide

Advertisement

ThinkVision Monitor L190
R
L190
English
User's Guide

Advertisement

Table of Contents
loading

Summary of Contents for Lenovo ThinkVision L190

  • Page 1 ThinkVision Monitor L190 L190 English User’s Guide...
  • Page 2 First Edition (July /2005) Note: For important information, refer to the Monitor Safety, Troubleshooting, and Warranty booklet that comes with this monitor. ii i...
  • Page 3: Table Of Contents

    Safety (Read first)...2 Setting up the monitor ...5 Product description ...5 Handling instructions...5 Security slot ...6 Workplace preparation ...7 Adjusting the monitor position...7 Working practices...8 Caring for your monitor ...8 Connecting your monitor...9 Turning on your monitor ...10 Device driver installation ...11 Windows 95/98...11 Windows 2000/Me...12 Windows XP ...13...
  • Page 5 Always observe the following precautions to reduce the risk of injury and property damage. Do not attempt to service a product yourself unless instructed to do so by the Lenovo Support Center. Use only an Lenovo authorized service provider who is approved to repair your particular product.
  • Page 6 In addition many mobile products such as ThinkPad notebook PCs utilize a rechargeable battery pack to provide system power when in portable mode. Batteries supplied by Lenovo for use with your product have been tested for compatibility and should only be replaced with Lenovo approved parts.
  • Page 7: Setting Up The Monitor

    Setting up the monitor Product description The ThinkVision Monitor, L190, is a TFT LCD Color Monitor. It requires a computer with a suitable on-board sub-system or Video Adapter card that can support SXGA 1280 x 1024, XGA 1024 x 768, SVGA 800 x 600, or VGA 640 x 480 at 60Hz.
  • Page 8: Security Slot

    Security slot This slot can be used to connect to a locking cable. Locking cables can be purchased separately at most computer stores. Security slot...
  • Page 9: Workplace Preparation

    3. Tilt the monitor to a comfortable viewing angle. Adjusting the monitor position With the Lenovo Flat Viewing angle Panel Monitor, you can You can tilt the screen forward and backward as shown below in Figure A.
  • Page 10: Working Practices

    Working practices This section gives advice Rest on how you can work Take regular breaks. Vary your posture, stand up and stretch occasionally comfortably and reduce as prolonged use of computer workstations can be tiring. fatigue. Back Sit back in your chair and use the backrest. Hands Adjust the seat height so that your forearms are approximately horizontal and your wrists are straight when using the keyboard.
  • Page 11: Connecting Your Monitor

    Connecting your monitor 1. Turn off your computer and all attached devices. Next, unplug all power Be sure to read the Safety Information located in the Monitor cords to your computer and all attached devices. Safety, Troubleshooting, and Warranty booklet before carrying 2.
  • Page 12: Turning On Your Monitor

    Turning on your monitor 1. Turn on your computer. 2. Turn on your monitor by pushing and releasing the power switch marked " at the front of the bezel. To turn off your monitor, push and release the power switch again. •...
  • Page 13: Device Driver Installation

    9. Ensure that the CD drive letter is selected, and then select the DRIVERS folder. 10. Select Lenovo L190 monitor and click OK. The files will be copied from the CD to your hard disk drive. 11. Close all open windows and remove the CD.
  • Page 14: Windows 2000/Me

    13. Click OK. 14. Ensure that the CD drive letter is selected, and then select the 15. Select Lenovo L190 monitor and click OK. The files will be copied from 16. Close all open windows and remove the CD. 17. Restart the computer.
  • Page 15: Windows Xp

    14. Ensure that the CD drive letter is selected, and then select the DRIVERS folder. 15. Select Lenovo L190 monitor and click OK. The files will be copied from the CD to your hard disk drive. 16. Close all open windows and remove the CD.
  • Page 16: Automatic Image Setup

    In order to optimize the displayed image a set-up utility is provided on the The Setup Utility included Lenovo User’s Guide and Installation Files CD. Operation of this utility is on the setup CD displays a dependent on the operating system on your computer. You may choose to test pattern of dots.
  • Page 17: Image Setup For Dos

    Image setup for DOS If the monitor is in standby To set up the monitor automatically in DOS, do the following. mode, it may automatically turn off while you are waiting for 1. Turn on the monitor first; then turn on the computer. it to warm up.
  • Page 18: Windows Me, Or Windows Xp

    Image setup for Windows 95, Windows 98, Windows NT, Windows 2000, Windows Me, or Windows XP If the monitor is in standby To set up the monitor automatically in Windows 95, Windows 98, Windows mode, it may automatically NT, Windows 2000, Windows Me, or Windows XP, do the following: turn off while you are waiting for it to warm up.
  • Page 19: Manual Image Setup

    Manual Image setup If the monitor is in standby Normally, you can complete the setup procedure using Automatic Image setup mode, it might automatically however, if your screen image is still distorted after you perform Image setup or turn off while you are waiting the setup CD does not run on your system, perform M for it to warm up.
  • Page 20: Adjusting Your Lcd Monitor

    Adjusting your LCD monitor User controls The image is already optimized for many display modes, however the user controls can be used to adjust the image to your liking. The settings are saved after adjustment and when exiting the OSD and USER CONTROL FEATURES will be effective thereafter.
  • Page 21: On-Screen Display (Osd) Controls

    On-screen display (OSD) controls The settings adjustable with the user controls are viewed through the On - The LCD monitor needs Screen Display (OSD). Press the enter button " time to become thermally menu. stable the first time you turn it on each day.
  • Page 22 OSD Icon The Image setup function is used to adjust the level of noise in the video signal, which causes horizontal lines Automatic or areas on the screen where the Image Setup image appears to be unstable and jitter or shimmer. This can be adjusted automatically or manually.
  • Page 23 OSD Icon Displays the detailed information of mode, model name, serial number and microcode. Information Options The language chosen affects only the language of the OSD. Select one of the six languages to use for the OSD. Language Your selection does not affect any software running on the computer.
  • Page 24: Further Information

    Further information Display modes If your computer has previously been used with a CRT monitor and is currently configured to a display mode outside the range that the Flat Panel monitor can display, you may need to re-attach the CRT monitor temporarily until you have reconfigured the computer, preferably to 1280 x...
  • Page 25: Power Management

    * There may be a slight delay before the picture reappears. Product disposal The fluorescent lamps in the liquid crystal display contain a small amount of mercury. Dispose of it as required by local ordinances and regulations. ® Partner, Lenovo has determined that this product Power Screen State Indicator...
  • Page 26: Troubleshooting

    Troubleshooting If you have a problem setting up or using your monitor, you may be able to solve it yourself. Before calling your retailer or Lenovo Support Center, try the suggested actions that are appropriate to your problem. Possible Problem...
  • Page 27 Problem Screen is blank and power indicator is flashing green every 0.5 second Check Signal Cable message is shown and power indicator is steady amber. Image appears to be smeared For image problems, you may want to run Image setup again before referring to this section.
  • Page 28: Help And Service Information

    If you are unable to correct the problem yourself, you may seek further help as follows: Customer Support center In other countries contact your dealer, retailer, or other Lenovo authorized If possible, stay by your computer. Your Technical service representative.
  • Page 29: Specifications

    Specifications This color monitor (Type-model 9329-Ax9) uses a 19.0-inch TFT LCD. Power consumption figures are for the monitor and the power supply combined. Weight Image Power Input Power Consumption Video Input Sync Input Communications Supported Display Modes Environment Without Stand Height: 346.0 mm (13.12 in.) Width:...
  • Page 30: Service Information

    Service information The following parts are for use by Lenovo service, or Lenovo authorized dealers, to support the customer warranty. Parts are for service use only. 40Y8380 73P4592 22P9262 40Y8385 40Y7469 Model Type 9329-Ax9 Description Video Analog Business Black FRU Monitor...
  • Page 31: Notices And Trademarks

    Consult your local Lenovo representative for information on the products and services currently available in your area. Any reference to a Lenovo product, program, or service is not intended to state or imply that only that Lenovo product, program, or service may be used. Any functionally equivalent product, program, or service that does not infringe any Lenovo intellectual property right may be used instead.
  • Page 32 Lenovo may use or distribute any of the information you supply in any way it believes appropriate without incurring any obligation to you. Any references in this publication to non-Lenovo Web sites are provided for convenience only and do not in any manner serve as an endorsement of those Web sites.

Table of Contents