Installing The Fork Protector; Removing The Lower Triple Clamp - Husqvarna 125 TC EU Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.10

Installing the fork protector

11.11

Removing the lower triple clamp

x
Main work
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B00306-10
Finishing work
–
Install the fork legs.
–
Install the front wheel.
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
Main work
–
Take off cable holder
–
Remove screw
–
Remove screw
–
Take off the upper triple clamp with the handlebar and set it aside.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
L01912-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
B01865-10
( p. 35)
x
( p. 65)
x
( p. 65)
x
( p. 34)
x
p. 39)
p. 40)
1
in front of the left radiator.
2 .
3
.
4
. Remove protective ring
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 33)
5
.
36
1
.