Ilo 2 Mp Reset Button; Resetting Local User Accounts And Passwords To Default Values; Console Serial Port And Auxiliary Serial Port; Console Serial Port (Rs-232) Connector - HP ntegrity iLO 2 MP Operation Manual

Table 2-1 iLO 2 MP Status LEDs (continued)
iLO 2 MP Status LED
iLO 2 MP Heartbeat
BMC Heartbeat

iLO 2 MP Reset Button

The iLO 2 MP Reset button enables you to reset the iLO 2 MP and reset the user-specific values
to factory default values. A momentary press causes a soft reset of the iLO 2 MP when the button
is released. A greater than four second press causes a soft reset of the iLO 2 MP upon release and
resets local user accounts and passwords to factory default values.

Resetting Local User Accounts and Passwords to Default Values

If iLO 2 MP user passwords are lost, or iLO 2 MP local user accounts are disabled and logging
in through LDAP directory server is unsuccessful because the directory server is down or directory
settings have not been configured properly in LDAP command, you can reset local user accounts
and passwords to their default values.
To reset local user accounts and passwords to default values, follow these steps:
1. Connect a serial terminal (or serial-cabled laptop with serial emulation) to the console serial
port.
2. Press and hold the iLO 2 MP Reset button for more than four seconds. The iLO 2 MP reboots
to factory default settings automatically.
3. Respond to the prompt to reset local user accounts and passwords to default values.

Console Serial Port and Auxiliary Serial Port

Figure 2-5 shows the console serial port connector with numbered labels for each pin on each
port.
Figure 2-5 Console Serial Port (RS-232) Connector
Table 2-2 maps the console serial port connector pin number to its signal description on each
port.
Table 2-2 Console Serial Port Pinouts
Pin Number
1
2
3
4
5
6
Flashing green.
Flashing green.
5
4
3
2
1
Signal Description
Not used
Receives data
Transmits data
Not used
Ground
Not used
LED State
9
8
7
6
iLO 2 MP Reset Button 31