Advertisement
CHARGING
THE HANDSET
1. Place the handset
on the base station for
12 hours.
The CHARGE
indicator
lights.
The base station must be connected
to
AC power. (See page 11.)
2. Remove the handset from the base
station. Your telephone
is now ready to
use.
When the BAIT
LOW indicator
lights,
recharge
the handset for a continuous
12
hours.
REPLACEMENT
BAITERY
CHARGE
indicator
'
If the battery fails, replacement
batteries
are available
from an authorized
Sanyo
~
service center.
(Replacement
battery: SANYO
3N-270AA)
STANDBY
TIME
When the handset
battery is fully charged,
your Sanyo cordless
phone offers up
to
3 weeks
of continuous
standby
time.
(Listed standby time is measured
under a situation
in which the handset
is kept in standby
mode only–no
phone
calls are made or received).
Under normal usage conditions,
recharging
is
required
more often.
1O-CHANNEL
ACCESS/AUTO
SCAN
This cordless
telephone
automatically
selects,
CHANNEL
every
time you answer or place a call using
the handset,
a clear channel
from 10 frequen-
0
ties available
to transmit
signals
between
the
base station and handset.
If you notice
interference
durina a call, simcrlv mess the
CAUTION
This telephone
is for use "tone dialing
system" only.
If you have a pulse dialing
line, you can't
use this cordless
telephone.
SECURITY
CODES
Your cordless
telephone
works only when the same security code is selected,
from 65,536 possibilities,
for both the handset
and base station. This prevents
unauthorized
use of your telephone
line by another
cordless
telephone.
IMPORTANT:
The following
events may cause the security code to be erased and require
resetting:
I
After the handset
battery is replaced
or exhausted
i
After a power interruption
To
reset your security code
1.
2.
Place the handset
in the base station
cradle.
Within 8 seconds,
press ~1
on the base station.
The IN USE indicator
blinks. A beep
sounds and the security code is set.
The IN USE indicator
then goes off.
If the security code cannot be set, the
fN USE
indicator
continues
to blink for
about 4 minutes.
When this occurs,
repeat the steps above.
If you experience
difficulty
in resetting
the
security code, first disconnect
the AC
adaptor from the unit, reconnect
it, and
then try again.
PAGE.$ No
Q
a clear channel.
4
(4
Advertisement
