Menu; E Setting The Power-Up Conditions And Data About The Screen Display - System Config Menu; Overview - Sony BVM-D9H1j Operation Manual

E
Setting the Power-Up Conditions and Data about
the Screen Display — SYSTEM CONFIG Menu

Overview

The SYSTEM CONFIG menu is displayed on the two
pages.
The SYSTEM CONFIG (1/2) menu is used for the
following settings:
• Power-up condition (STANDBY MODE menu)
This menu sets the condition of the monitor when the
MAIN POWER switch on the rear panel is switched
on (BVM-D14H1U/D14H1E/D14H1A/D14H5U/
D14H5E/D14H5A) or when the battery is installed
(BVM-D9H1U/D9H1E/D9H1A/D9H5U/D9H5E/
D9H5A.)
• Power-up input channel (DEFAULT CH menu)
This menu sets the power-up input channel.
• Time from power-up until degauss (DEGAUSS
DELAY menu)
If several monitors are turned on at the same time and
all start degaussing at the same time, there will be a
very large current draw on the power supply for a few
moments. To prevent this, the delay time between
power-up and degaussing can be set for each monitor
independently.
• Setting of the contrast and brightness after
adjusting the white balance (CONT/BRT HOLD

menu)

Selects if the adjusted contrast and brightness are
retained or they are reset to the center values, when
the color temperature is adjusted in the COLOR
TEMP ADJ menu.
• Assigning shortcut to the COLOR TEMP ADJ
menu to the [F2] key (COL TEMP SHORT-CUT
menu)
Assigns the shortcut to the MANUAL menu of the
COLOR TEMP ADJ menu to the [F2] key. This
allows you to jump directly to the MANUAL menu
corresponding to the color temperature set to the
currently displayed image (STD/COL 1/COL 2.)
• Auto color control (ACC SW menu) (when using
the BKM-127W)
Selects if the ACC (Auto Color Control) circuit is
turned on or off.
• Selecting the monitor to copy the original data
(CONFIG COPY menu)
Setting data of the INPUT CONFIG and SYSTEM
CONFIG (except the DEGAUSS DELAY data)
menus can be copied from the serial connected
monitor.
The SYSTEM CONFIG (2/2) menu is used for the
following settings:
• Display mode and position of the signal format
(FORMAT DISPLAY and POSITION menus)
• Display mode and position of the channel number
(CH NO and POSITION menus)
• Display mode and position of the channel name
(CH NAME and POSITION menus)
• Display mode of the caption (CAPTION menu)
• Maintenance (MAINTENANCE menu)
This is for a service qualified personnel.
39
(E)