Yamaha 2004 YP400 Service Manual page 169

1
2
a
FRONT AND REAR BRAKES
2. Install:
• brake master cylinder 1
• brake master cylinder holder 2
NOTE:
• Make sure to install the brake master cylin-
a
der holder that has the "L" mark.
• Install the brake master cylinder holder with
the "UP" mark facing up.
• Align the end of the brake master cylinder
holder with the punch mark a on the handle-
bar.
• First, tighten the upper bolt, then the lower
bolt.
3. Install:
• copper washers
• brake hose
• union bolt
_
Proper brake hose routing is essential to
insure safe scooter operation. Refer to
"CABLE ROUTING" in chapter 2.
NOTE:
_
• While holding the brake hose, tighten the
union bolt as shown.
• Turn the handlebar to the left and right to
make sure the brake hose does not touch
other parts (e.g., wire harness, cables,
leads). Correct if necessary.
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe touches the projections a on the
brake master cylinder.
4 - 29
10 Nm (1.0 m · kg, 7.2 ft · lb)
New
30 Nm (3.0 m · kg, 22 ft · lb)
WARNING
CHAS