Sony Cyber-shot DSC-HX1 Instruction Manual page 70

70 GB
The remaining charge indicator is incorrect.
• The battery charge will quickly get used up and the actual remaining battery charge will be
lower than the indicator in the following cases:
- When you use the camera in an extremely hot or cold location.
- When you use the flash and zoom frequently.
- When you repeatedly tum the power on and off.
- When you set the screen brightness higher using DISP (screen display) settings.
• A discrepancy arose between the remaining charge indicator and the actual remaining battery
charge. Fully discharge the battery pack once, then charge it to correct the indication.
• The battery pack is discharged. Insert the charged battery pack (page 13).
• The battery pack is dead. Replace it with a new one.
Cannot charge the battery pack while it is inside the camera.
• You cannot charge the battery pack using the AC Adaptor (sold separately). Use the battery
charger (supplied) to charge the battery.
The CHARGE lamp flashes while charging the battery.
• Remove and reinsert the battery pack, making sure it is installed correctly.
• The temperature may be inappropriate for charging. Try charging the battery pack again
within the proper charging temperature range (10 °C to 30°C (50 OF to 86 OF)).
Shooting still images/movies
Cannot record images.
• Check the free capacity of the internal memory or "Memory Stick Duo" media (pages 32, 45).
If it is full, do one of the following:
- Delete unnecessary images (page 48).
- Change the "Memory Stick Duo" media.
• You cannot record images while charging the flash.
• When shooting a still image, set the mode dial to other than
0
(Movie Mode).
• Set the mode dial to
0
(Movie Mode) when shooting movies.
• You can record movies with an image size of [1440xI080(Fine)], [1440xI080(Standard)] or
[1280x720] on "Memory Stick PRO Duo" media. When using recording media other than
"Memory Stick PRO Duo" media, set the movie image size to [VGA].
• The camera is in Smile Shutter demonstration mode. Set [Demo Mode] to [Off].
Cannot create panoramic images.
• Pan the camera as the guidance bar with a constant velocity. You cannot create panoramic
images in the following situations:
- Pan the camera too fast or too slow.
- Pan the camera in the different direction from the setting.
• If there is too much camera shake during panning, the shooting stops. Hold the camera firmly.