Table of Contents
Advertisement
WHAT TO DO IF
If the operation of the unit or display is not normal, or you wish
to clear the contents of the memory.
1. Disconnect the power cord from AC outlet.
2. Press the RESET button for at least 30 seconds.
3. Connect the power cord.
4. Press the POWER button to turn the power on.
I
w
CD PICK-UP MAINTENANCE
About pick-up (Opticai iens) Cieaning
Clean the lens with the specified cleaning disc or moisten a cotton swab with isopropyl alcohol and cleaning
paper.
Specified cleaning disc: LC-1 (Part code: 645026
1961 ..... manufactured
by SANYO.)
Regarding procedure of cleaning with moisten cotton swab, please refer to the attached as follows.
1. Cotton swab wrapped
with Cleaning paper.
2. Add the isopropyl alcohol.
3. Gently move the tip of cotton swab just like a draw a whirlpool from inside to outside on the surface of lens.
SERVICE
MODE
1.
Preparation
Press the unit's STOP and FM MODE buttons at the same time. (This initiates service mode entry status.)
Next, press another button on the unit to switch to the corresponding
service mode.
The unit enters a sewice mode only if another button is pressed during that 1 second.
2.
CD Repair
1.
2.
3.
Within 1 second of activating service mode entry status, press the CD BACK button to enter this sewice mode.
When in the CD function mode the LCD segment displays a CD operation indication that is different from its normal indication.
If a CD error occurs, a display appears as shown in below.
Also, from the point at which the error occurred onward, the CD operation display is fixed. The fixed displays is canceled
by
pressing the STOP button when the CD is stopped.
Press the POWER button to cancel this mode.
Disc No.
State of CD Error
o
Good
1
Focusing is not possible in focus serch.
2
The subcode is not input during disc startup.
3
TOC can not be read.
4
Focus was lost while the servo was on. (during playing, etc.)
5
The subcode is not input while the servo in on. (during playing, etc.)
3.
Checking the FL connection
1.
2.
3.
4.
Within 1 second of activating service mode entry status, press the TUNING UP button to enter this service mode.
FL and LED turns on order when enter this mode.
When every indication turns on, become on and off light indication.
Press the POWER button to cancel this mode.
-2-
Advertisement
Table of Contents
