Hitachi G 10SD2 Technical Data And Service Manual page 16

(4) Connect the four internal wires of Stator (A) [12] <12> with the parts indicated in Fig. 7.
Connect the internal wires correctly as shown in Fig. 8.
Connect to the Brush
Holder [40] <41> (Side B)
Connect both the internal wire of the Noise
Suppressor [47] <48> and this wire to Tube
(D) [48] <49> with a solderless connection
and connect it to the Slide Switch [44] <45>.
(If the Noise Suppressor [47] <48> is not
used, connect this internal wire to the Slide
Switch [44] <45> after clamping Tube (D) [48]
<49> with the solderless connection.)
a. Noise suppressor provided
Connect to the Brush
Holder [40] <41> (Side A)
Side A
Fig. 7
b. Noise suppressor not provided
Fig. 8
--- 13 ---
Side B