Sanyo TLS-1960P Service Manual page 4

Error Codes (Self-Diagnosis Contents)
No.
The cylinder does not rotate.
E01
The tape winds around the cylinder.
E02
The take-up reel does not rotate.
E03
The capstan motor does not rotate.
The tape can not be loaded.
E04
(But unloading can be performed.)
The tape can be loaded with the cassette inserted.
But unloading can not be performed or the loading and
E05
unloading cannot be performed with the cassette in-
serted. (The tape guide is caught.)
Front unloading cannot be performed when ejecting
E06
the cassette. (Front loading can be performed.)
Front loading and front unloading cannot be per-
E07 formed when ejecting the cassette. (The cassette is
caught in the mechanism front.)
The mechanism becomes 7 (INITIAL) while moving
from 1 (BRAKE), 2 (STOP), 3 (PLAY), 4 (STILL/
E09
SLOW), and to 5 (REVERSE FRAME ADVANCE).
(The mechanism mode switch is faulty.)
The capstan motor does not rotate, or the capstan
E10 motor and the cylinder motor does not rotate with the
cassette inserted.
The cylinder motor does not rotate with the
E11
cassette inserted.
The supply reel does the tape eject when tape
E12
unloading.
The tape cannot be loaded with the cassette
E13
inserted.
E14 The tape cannot be loaded normally.
The mechanism does not move to the correct
E15
position after tape loading.
Mechanism position "3" cannot be used during
E16
intermittent recording.
Mechanism Mode Display Contents
Mode. No. Mechanism mode
00 CASSETTE OUT
01
STAND-BY
02
STOP
03
STILL
04 REC-PAUSE
06 FRAME ADVANCE
08
PLAY
Problem
Mode. No. Mechanism mode
09 REC
12 CUE
13 REVIEW
14 FAST FORWARD
15 REWIND
30 REVERSE PLAY
31 REVERSE FRAME ADVANCE
– 4 –
Mechanism Operations and State After Occurrence
Shift to the STOP mode.
Unload forcibly.
Shift to the STOP mode.
Shift to the STOP mode.
Unload, shift to the ST-BY mode, and the power goes
off.
The power is forcibly turned off with the mechanism
at its current position.
Front loading, shift to the STOP mode or ST-BY mode.
The power is forcibly turned off with the mechanism
at its current position.
Carry out the tape take-up operations, and shift to
STOP mode.
Shift to the EJECT mode.
Shift to the EJECT mode.
Shift to the EJECT mode.
Shift to the EJECT mode.
Shift to the EJECT mode.
The power is forcibly turned off with the mechanism
at its current position.
Shift to the STOP mode.
Mode. No.
32
33
Mechanism mode
INTERMITTENT REC
REVERSE STILL