Installing The Network Daughter Card; Processors - Dell DL4000 Owner's Manual

Figure 20. Removing and installing the network daughter card
1. captive screw sockets (2)
3. captive screws (2)
5. network daughter card

Installing the network daughter card

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: If you are installing the 10 Gb network daughter card, ensure that you install the network
daughter card cooling shroud in your system.
1. Angle the card so that the RJ-45 connectors fit through the slot in the back panel.
2. Align the captive screws at back-end of the card with the screw holes on the system board.
3. Press the touch point on the card to ensure that connector on the card is in contact with the
connector on the system board.
4. Using a #2 Phillips screwdriver, tighten the two captive screws to secure the network daughter card
to the system board.
5. Install the expansion-card riser 3.
6. Close the system.
7. Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.

Processors

Use the following procedure when replacing a processor.
2. connector on the system board
4. touch point
6. back panel slots for RJ-45 connectors
49