Download
Share
Print this page
Toro TimeCutter Setup Instructions
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. TimeCutter
  6. Setup instructions
Toro TimeCutter Setup Instructions

Toro TimeCutter Setup Instructions

Riding mowers
Hide thumbs Also See for TimeCutter:
1
2
3
4

Advertisement

Quick Links

Download this manual
TimeCutter™ Riding Mowers
Model No. All models

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine from the normal operating position.
1

Setting Up the Motion Control Levers

No Parts Required
Procedure
1. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch) as shown in Figure 1.
Raise the motion control levers.
2. Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer
removed previously (Figure 1). Hand tighten all fasteners. Repeat this for both controls levers.
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
No parts required
Ignition Key
Hose coupling
Operator's Manual
Engine Operator's Manual
Operator Training Material
Register at www.Toro.com.
Qty.
–
Set up the motion control levers.
–
Connect the battery.
1
1
1
Complete the Setup.
1
1
Figure 1
Form No. 3363-807 Rev A
Setup Instructions
Use
Original Instructions (EN)
Printed in the USA.
All Rights Reserved

Advertisement

loading

Related Manuals for Toro TimeCutter

Summary of Contents for Toro TimeCutter

  • Page 1: Loose Parts

    Form No. 3363-807 Rev A TimeCutter™ Riding Mowers Model No. All models Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Set up the motion control levers.
  • Page 2 3. Open the motion control levers and raise the seat (Figure 2). Move the control levers back to the center position (neutral). G006481 Figure 2 4. Verify the motion control levers are properly aligned (Figure 3). Adjust as necessary. Tighten all fasteners. G006482 Figure 3...

  • Page 3: Connecting The Battery

    Connecting the Battery Completing the Setup No Parts Required Parts needed for this procedure: Ignition Key Procedure Hose coupling 1. Locate the battery and negative battery cable in the Operator’s Manual left hand console of the machine. Engine Operator’s Manual 2.