Panasonic UF-9000 Service Handbook page 56

Code Mode
722 RCV
725 XMT
POP
726 XMT
POP
728 XMT
729 XMT
730 RCV
731 RCV
741 XMT, Polling PSTN Unable to dial
800 Relay
Comm.
814 Conf. XMT
Conf. Polling
Relay
Comm.
815 Conf. RCV
816 Conf. Polled
825 Conf. RCV
Conf. Polled
826 RCV
870 MEM XMT
Multi-Copy
879 Memory
RCV
Ver. 2.0
Fax Information Codes
Phase Description of Problem
LAN Failed to obtain the Network
Parameters (such as: IP Address,
Subnet Mask, Default Gateway IP
Address, etc.) from the DHCP
server.
LAN DNS Server connection timed out. Incorrect DNS Server address is set.
LAN Received an error response from
the DNS Server.
LAN Received an Error or No
Response from the Remote
Internet Fax. (SMTP Direct XMT)
LAN Failed to authenticate (SMTP
AUTHENTICATION) when
connecting with the SMTP server.
LAN Unable to program the Internet
parameters or the autodialer with
Email from a PC.
LAN Dialer full while Relayed
Transmission Request was
received.
PSTN The machine was requested to
relay a document but has no Relay
Hub capability.
The remote station does not have
Relay XMT nor Confidential
Communication capability.
Mailbox is full.
"The received Polling Password
did not match. The machine does
not have Confidential Comm.
capability."
Parameter settings of the initial
sending station are not properly
set.
B If applicable sub-address is not
registered in the phone book of the
receiver side when using sub-
addressing function.
PSTN Memory overflow occurred while
storing documents into memory.
PSTN Memory overflow occurred during
substitute memory reception.
LAN Memory overflow.
Mail Server sent a reset command
while downloading the data to the
machine.
LAN Cable is disconnected.
DHCP is not available.
(Contact the Network Administrator.)
DNS Server is down.
Incorrect POP Server address is set.
Incorrect SMTP Server address is set.
Remote Internet Fax Errors: Busy,
Memory Overflow, or No Power.
Job Number Overflow for Relay XMT
SMTP AUTHENTICATION, User Name
and/or Password are incorrect.
(Contact the Network Administrator.)
Verify that the Fax Parameter #158 is
set to 2: Valid.
Dial buffer for manual number dialing
(70 stations) are being used.
Deleted the registered station name
before dialing with Timer Controlled
Communications, etc.
Receiver side does not have correct
sub-address in their phone book.
Memory overflow on the Fax side.
Memory overflow on the Fax side.
Mail server aborted the download (Busy
with other higher priority jobs).
56
UF-9000
DP-180/190
Cause
JUN 2004