Program Mode - Coomber 2241 Operating Instructions

THE CD PLAYER
Ensure the TAPE/CD selector switch
(4) is IN for CD playback
ATTENTION
In common with many CD players, it
takes a few moments for the player
to run a diagnostic check.
Do not press any buttons until the
LCD display has stopped flashing.
PLEASE NOTE: ALWAYS CLOSE
THE CD TRAY WITH THE UNIT
SWITCHED ON. PUSHING THE
TRAY CLOSED WITH THE
POWER OFF MAY LEAD TO
DAMAGE DURING
SUBSEQUENT
TRANSPORTATION.
REMOTE SENSOR
Infra red sensor allows
operation of CD player
by the RM05 remote
control.

Program Mode

The CD player can be programmed to play any
combination of tracks, in any order, on a CD. To
do so, simply do the following:-
1 Insert a CD and wait for the display to show the
number of tracks and the total CD time.
2 Press PROG once, then select a track using the
REV/B.SKIP or CUE/F.SKIP buttons.
3 Repeat the process until all of the required
tracks have been included.
4 Press PLAY to begin listening. The word PROG is
displayed permanently while the programmed
play list is playing.
Notes
· You can use REV/B.SKIP, CUE/F.SKIP and PAUSE
in program mode, but pressing STOP, or
ejecting the CD will cancel the memory.
· After 10 seconds of inactivity the PROG mode
will shut down. Don't worry, simply press PROG
again to return to the mode. Any input
information will still be available (up to the last
time the PROG button was pressed).
through the track being played.
REVIEW/BACK SKIP
Press once to skip back a track,
press and hold to review
through the track being played.
CD TRAY
Can be closed by pushing
gently or by pressing the
OPEN/CLOSE button.
TRACK NUMBER
Up to 99 tracks can be
selected and played.
TIME CLOCK
Shows total length of CD in minutes and
seconds, track time elapsed or total time
remaining of any CD playing.
Press to show how much total CD
playing time remains. Press again
to revert to track time elapsed.
CUE/FORWARD SKIP
Press once to skip forward a
track, press and hold to cue
REMAIN
MUTE
Press to mute sound. CD continues
to play while MUTE is selected.
Press again to cancel.
STOP
Press once to stop playing CD.
The CD player will reset itself.
Note: Random, Prog and Repeat settings
will be lost when STOP is depressed.
PLAY/PAUSE
Press once to go play a track. Press
again to pause play (seconds counter
will flash). Press again to cancel pause
mode and continue playing.
OPEN/CLOSE
Opens and closes the CD tray.
Overides all other functions.
REPEAT
Press once to repeat current track,
press twice to repeat complete CD.
Press again to cancel.
PROG
Press to programme CD player for
personalised playback order (see below).
RANDOM
Press to allow the CD player to randomly
select the play order of the tracks on the
current CD. Press again to cancel.
INTRO
Press to play the first ten seconds of
each track. Press again to cancel.
REMOTE
CONTROL
The RM05 CD
remote unit
emulates the
controls found
on the CD player
and is able to
initiate all CD
functions.