Squeegee System; Functional Description; Component Locations - Nilfisk-Advance Advance SC750 Service Manual

Service Manual: SC750, SC800, SC 750 ST, SC800 ST

Squeegee System

Functional Description

The squeegee collects the water so that the recovery system vacuum can suck it up off the floor and store it in the recov-
ery tank. The squeegee support is spring loaded downward to push the squeegee against the floor, and has a pivot point
that allows the squeegee to "swing" around corners. The squeegee tool rides along the floor on two small wheels and
is raised and lowered with a hand operated lever. To prevent damage to the squeegee tool in the event that the tool is
caught by an obstacle, it is mounted to the support frame in slotted holes and is fastened by two hand tightened "wing
nuts". The squeegee angle can be adjusted for optimum floor wiping. The squeegee tool has a front and a rear blade.
Each blade has 4 working edges that can be used before the blade is replaced. The front squeegee blade has slots along
the bottom edge to allow the necessary air flow to carry the water. The rear squeegee blade edge is flat.

Component Locations

• Squeegee Support
• Squeegee Tool
• Squeegee Lift Lever
Form Number 56043150
• Break Away Slots
• Tilt Adjustment Knob
Page 112