Advertisement
Installation steps
1. Mount the device on a DIN rail inside an appropriate enclosure
2. Connect supply cables feed from the appropriately rated protection.
3. Connect Ethernet and Dynet data cables to the device as per label on device.
4. Power up device once all termination have been re checked.
5. The unit will need to be configured using Envision commissioning tool
connecting data cable
product specifications
Supply:
Serial Port 1:
Serial Port 2:
RS485 Data Formats:
User Controls:
Internal Controls:
Operating Environment:
Power Consumption:
Compliance:
Construction:
Dimensions:
Weight:
Philips Dynalite manufactured by WMGD Pty Ltd (ABN 33 097 246 921) Unit 6, 691 Gardeners Road Mascot NSW 2020 Australia Tel: +61 2 8338 9899 Fax: +61 2 8338 9333
230 +/- 14% 50/60Hz Single Phase
1 x 10/100BaseT Ethernet, consisting of 1 x RJ45 socket
1 x RS485 unterminated, consisting of 1 x RJ12 socket & 1 x 5 way terminal block
DyNet, DyNet II
Service Switch, Diagnostic LED
Programmable Logic Controller, 64 Tasks
0º to 50ºC ambient temperature, 0% to 95% RH non condensing
450mA from the DyNet network at 12VDC
CE, C-Tick
Polycarbonate DIN Rail enclosure (12 unit)
H 93mm x W 211mm x D 75mm
0.86kg
DDNG100BT Installation Manual Rev B.doc Specifications subject to change without notice
E-Mail: dynalite.info@philips.com
Web: Philips.com/dynalite
Advertisement
